AM-AMC-176 MACOM | Alldatasheet
Document overview
- Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
- PDF pages: 3
Technical content
Features
n 4.0 dB Typical Noise Figure n 13.5 dBm Typical Midband 1 dB Compression n 1.25:1 Typical VSWR
Description
M/A-COM’s AM -176 is a feedback amplifier with high intercept and compression points. This amplifier is packaged in a TO -8 package. Due to the internal power dissipation the thermal rise should be minimized. The ground plane on the PC board should be configured to remove heat from under the package. AM -176 is ideally suited for use where a high intercept, high reliability amplifier is required. Cascadable Thin Film Amplifier, 13 dB Gain, 5 - 1000 MHz AM-/AMC-176 TO-8-1 C-32 Absolute Maximum Ratings 1 1. Operation of this device above any one of these parameters may cause permanent damage. Parameter Absolute Maximum Max Input Power +10 dBm Vbias +15.75 V Operating Temperature -55°C to +85°C Storage Temperature -65°C to +125°C V 3.00
Cascadable Thin Film Amplifier, 13 dB Gain, 5 - 1000 MHz AM-/AMC-176 Specifications subject to change without notice. n North America: Tel. (800) 366-2266 n Asia/Pacific: Tel.+81-44-844-8296, Fax +81-44-844-8298 n Europe: Tel. +44 (1344) 869 595, Fax+44 (1344) 300 020 Visit www.macom.com for additional data sheets and product information. V 3.00 Electrical Specifications 2,3 TA = -55°C to +85°C Case Temperature Parameter Test Conditions Frequency Units Min. Typ. Max. Gain @ +25°C 500 MHz dB 12.2 13.2 14.2 Frequency Response — 5 - 1000 MHz dB — — ±1.0 Gain Variation with Temperature — 5 - 1000 MHz dB — — ±1.0 1 dB Compression Output Power 5 - 1000 MHz dBm +12 — — Noise Figure — 5 - 1000 MHz dB — — 5.0 Reverse Transmission — 5 - 1000 MHz dB — -17 -14 VSWR — 5 - 1000 MHz Ratio — — 1.8:1 Output IP2 Two-tone inputs up to 0 dBm 5 - 1000 MHz dBm +37 — — Output IP3 Two-tone inputs up to 0 dBm 5 - 1000 MHz dBm +25 — — Ibias Vbias = +15.0 VDC — mA — 38 43 Power Dissipation @ +15V Bias — mW — 570 — 2. All specifications apply when operated at +15 VDC, with 50 ohms source and load impedance. 3. Heat Sinking: Operation at case temperature above 95°C is not recommended. Heat sinking adequate to dissipate 650 mW must be provided in use. S-Parameter Data S11 S21 S12 S22 MAG ANG MAG ANG MAG ANG MAG ANG Frequency (MHz)
Cascadable Thin Film Amplifier, 13 dB Gain, 5 - 1000 MHz AM-/AMC-176 Specifications subject to change without notice. n North America: Tel. (800) 366-2266 n Asia/Pacific: Tel.+81-44-844-8296, Fax +81-44-844-8298 n Europe: Tel. +44 (1344) 869 595, Fax+44 (1344) 300 020 Visit www.macom.com for additional data sheets and product information. V 3.00 Typical Performance Curves Noise Figure
Ordering Information
Gain vs. Frequency VSWR vs. Frequency 3 5 10 20 50 100 300 500 700 900 1100 Frequency (MHz) Output Power (dBm) 3 5 10 20 50 100 300 500 700 900 1100 Frequency (MHz) Gain (dB) +85°C +25°C -55°C 1.0 1.2 1.4 1.6 3 5 10 20 50 100 300 500 700 900 1100 Frequency (MHz) VSWR RF IN RF OUT 3.5 4.0 4.5 5.0 3 5 10 20 50 100 300 500 700 900 1100 Frequency (MHz) Noise Figure (dB) +85°C +25°C 5 10 20 50 100 300 500 700 900 1000 1100 Frequency (MHz) Intercept (dBm) IP2 (f1+f2) IP2 (f1-f2)IP3