AMC-AMS-162 MACOM | Alldatasheet
Document overview
- Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
- PDF pages: 3
Technical content
Features
n 1.1 dB Typical Low Noise Figure @ 50 MHz n +15 dBm Typical High Output Power @ 50 MHz n +32 dBm Typical Third Order Intercept @ 50 MHz n Fully Hermetic Package (AM-162, AMS-162)
Description
M/A-COM’s AM-162 is a coupler feedback amplifier with high int ercept and compression points. The use of coupler feedback minimizes noise figure and current in a high intercept amplifier. This amplifier is packaged in a flatpack with flanges. Due to the internal power dissipation the thermal rise minimized. The gro und plane on the PC board should be configured to remove heat from under the package. AM -162 are ideally suited for use where a high intercept, high reliability amplifier is required. Low Noise Amplifier, 12.5 dB Gain, 10 - 100 MHz AM-/AMC-/AMS-162 TO-8-1 SF-1 V3.00
Low Noise Amplifier, 12.5 dB Gain, 10 - 100 MHz AM-/AMC-/AMS-162 Specifications subject to change without notice. n North America: Tel. (800) 366-2266 n Asia/Pacific: Tel.+81-44-844-8296, Fax +81-44-844-8298 n Europe: Tel. +44 (1344) 869 595, Fax+44 (1344) 300 020 Visit www.macom.com for additional data sheets and product information. V3.00 Electrical Specifications 1 TA = -55°C to +85°C Case Temperature Parameter Test Conditions Frequency Units Min. Typ. Max. Gain @ +25°C 50 MHz dB 12.0 12.5 13.0 Frequency Response — 10 - 100 MHz dB — — ±0.6 Gain Variation with Temperature — 10 - 100 MHz dB — — ±0.6 1 dB Compression Output Power 10 - 100 MHz dBm +13 — — Noise Figure — 10 - 100 MHz dB — — 1.6 Reverse Transmission — 10 - 100 MHz dB — -15 -14 VSWR — 10 - 100 MHz Ratio — — 2.0:1 Output IP2 Two-tone inputs up to 0 dBm 10 - 100 MHz dBm +40 — — Output IP3 Two-tone inputs up to 0 dBm 10 - 100 MHz dBm +26 — — Vbias — — VDC +14.5 +15.0 +15.5 Ibias Vbias = +15.0 VDC — mA — 11 15 Power Dissipation @ +15V Bias — mW — 165 — S-Parameter Data S11 S21 S12 S22 MAG ANG MAG ANG MAG ANG MAG ANG Frequency (MHz) 1. All specifications apply when operated at +15 VDC, with 50 ohms source and load impedance. Pin Configuration (For AMS-162) Pin No. Function Pin No. Function
1 RF OUT 3 RF IN
2 VDC 4 GND
Absolute Maximum Ratings 2 2. Operation of this device above any one of these parameters may cause permanent damage. Parameter Absolute Maximum Max. Input Power +10 dBm Vbias +15.75 V Operating Temperature -55°C to +85°C Storage Temperature -65°C to +125°C
Low Noise Amplifier, 12.5 dB Gain, 10 - 100 MHz AM-/AMC-/AMS-162 Specifications subject to change without notice. n North America: Tel. (800) 366-2266 n Asia/Pacific: Tel.+81-44-844-8296, Fax +81-44-844-8298 n Europe: Tel. +44 (1344) 869 595, Fax+44 (1344) 300 020 Visit www.macom.com for additional data sheets and product information. V3.00 Typical Performance Curves VSWR vs. Frequency Gain vs. Frequency Noise Figure 1 dB Compression Intermodulation Intercept Ordering Information Part Number Package AM-162 PIN TO-8-1 AMC-162 SMA C-6 AMS-162 PIN SF-1 5 10 20 30 40 50 75 100 125 Frequency (MHz) Output Power (dBm) 1.0 1.5 2.0 2.5 5 10 20 30 40 50 75 100 125 Frequency (MHz) Noise Figure (dB) +85°C +25°C 5 10 20 30 40 50 75 100 125 Frequency (MHz) Intercept (dBm) IP2 (f1+f2) IP3 IP2 (f1-f2) 1.0 1.4 1.8 2.2 5 10 20 30 40 50 75 100 125 Frequency (MHz) VSWR RF IN RF OUT 11.0 12.0 13.0 14.0 5 10 20 30 40 50 75 100 125 Frequency (MHz) Gain (dB) +85°C +25°C -55°C