AM-AMC-155 MACOM | Alldatasheet
Document overview
- Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
- PDF pages: 3
Technical content
Features
n 2.5 dB Typical Midband Noise Figure n +21 dBm Typical Midband Output Power n +37 dBm Typical Midband Third Order Intercept
Description
M/A-COM’s AM-155 is a coupler feedback amplifier with high intercept and compression points. The use of coupler feedback minimizes noise figure and current in a high intercept amplifier. This amplifier is packaged in a TO -8 package. Due t o the internal power dissipation the thermal rise minimized. The ground plane on the PC board should be configured to remove he at from under the package. AM-155 is ideally suited for use where a high intercept, high reliability amplifier is required. High Dynamic Range Amplifier, 12.5 dB Gain, 300 - 1000 MHz AM-/AMC-155 TO-8-1 C-32 Absolute Maximum Ratings 1 1. Operation of this device above any one of these parameters may cause permanent damage. Parameter Absolute Maximum Max. Input Power +10 dBm Vbias +15.75 V Operating Temperature -55°C to +85°C Storage Temperature -65°C to +125°C V 3.00
High Dynamic Range Amplifier, 12.5 dB Gain, 300 - 1000 MHz AM-/AMC-155 Specifications subject to change without notice. n North America: Tel. (800) 366-2266 n Asia/Pacific: Tel.+81-44-844-8296, Fax +81-44-844-8298 n Europe: Tel. +44 (1344) 869 595, Fax+44 (1344) 300 020 Visit www.macom.com for additional data sheets and product information. V 3.00 Electrical Specifications 2,3 TA = -55°C to +85°C Case Temperature Parameter Test Conditions Frequency Units Min. Typ. Max. Gain @ +25°C 600 MHz dB 11.25 12.25 13.25 Frequency Response — 300-1000 MHz dB — — ±0.5 Gain Variation with Temperature — 300-1000 MHz dB — — ±0.7 1 dB Compression Output Power 300-1000 MHz dBm +18 — — Noise Figure — 300-700 MHz 300-1000 MHz dB dB 4.0 5.5 Reverse Transmission — 300-1000 MHz dB — -14 -10 VSWR Input Output 300-1000 MHz Ratio Ratio 2.0:1 3.0:1 Output IP2 Two-tone inputs up to +5 dBm 300-1000 MHz dBm +40 — — Output IP3 Two-tone inputs up to +5 dBm 300-1000 MHz dBm +27 — — Vbias — — VDC +14.5 +15.0 +15.5 Ibias Vbias = +15.0 VDC — mA — 50 60 Power Dissipation @ +15V Bias — mW — 750 — 2. All specifications apply when operated at +15 VDC, with 50 ohms source and load impedance. 3. Heat Sinking: Operation at case temperature above 95°C is not recommended. Heat sinking adequate to dissipate 0.9W must be provided in use. S11 S21 S12 S22 MAG ANG MAG ANG MAG ANG MAG ANG Frequency (MHz) S-Parameter Data
High Dynamic Range Amplifier, 12.5 dB Gain, 300 - 1000 MHz AM-/AMC-155 Specifications subject to change without notice. n North America: Tel. (800) 366-2266 n Asia/Pacific: Tel.+81-44-844-8296, Fax +81-44-844-8298 n Europe: Tel. +44 (1344) 869 595, Fax+44 (1344) 300 020 Visit www.macom.com for additional data sheets and product information. V 3.00 Typical Performance Curves Noise Figure
Ordering Information
- Mounting kit part number AU00071 required for PCB applications. Part Number Package AM-155 PIN4 TO-8-1 AMC-155 SMA Connectorized 1 dB Compression Intermodulation Intercept Gain vs. Frequency VSWR vs. Frequency 0 200 400 600 800 1000 1200 Frequency (MHz) Output Power (dBm) 200 400 600 800 1000 1200 Frequency (MHz) Gain (dB) +85°C +25°C -55°C 0 200 400 600 800 1000 1200 Frequency (MHz) Noise Figure (dB) +85°C +25°C 0 200 400 600 800 1000 1200 Frequency (MHz) Intercept (dBm) IP2 IP3 1.0 1.5 2.0 2.5 3.0 3.5 0 200 400 600 800 1000 1200 Frequency (MHz) VSWR RF IN RF OUT