AM-AMC-147 MACOM | Alldatasheet
Document overview
- Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
- PDF pages: 3
Technical content
Features
n 2 dB Typical Midband Noise Figure n +20 dBm Typical Midband Output Power n +38 dBm Typical Midband Third Order Intercept
Description
M/A-COM’s AM-147 is a coupler feedback amplifier with high intercept and compression points. The use of coupler feedback minimizes noise figure and current in a high intercept amplifier. This amplifier is packaged in a TO -8 package. Due to the internal power dissipation the thermal rise minimized. The ground plane on the PC board should be configured to remove heat fro m under the package. AM-147 is ideally suited for use where a high intercept, high reliability amplifier is required. High Performance Amplifier, 17 dB Gain, 5 - 500 MHz AM-/AMC-147 TO-8-1 C-32 Absolute Maximum Ratings 1 1. Operation of this device above any one of these parameters may cause permanent damage. Parameter Absolute Maximum Max. Input Power +10 dBm Vbias +15.75 V Operating Temperature -55°C to +85°C Storage Temperature -65°C to +125°C V 3.00
High Performance Amplifier, 17 dB Gain, 5 - 500 MHz AM-/AMC-147 Specifications subject to change without notice. n North America: Tel. (800) 366-2266 n Asia/Pacific: Tel.+81-44-844-8296, Fax +81-44-844-8298 n Europe: Tel. +44 (1344) 869 595, Fax+44 (1344) 300 020 Visit www.macom.com for additional data sheets and product information. V 3.00 Electrical Specifications 2,3 TA = -55°C to +85°C Case Temperature Parameter Test Conditions Frequency Units Min. Typ. Max. Gain @ +25°C 50 MHz dB 16.4 17.0 17.6 Frequency Response — 5 - 500 MHz dB — — ± 1.0 Gain Variation with Temperature 1 dB Compression Output Power 5 - 500 MHz dBm +19 — — Noise Figure — 5 - 500 MHz 5 - 300 MHz dB dB 4.5 3.5 Reverse Transmission — 5 - 500 MHz dB — -20 -16 VSWR — 5 - 500 MHz Ratio — — 2.0:1 Output IP2 Two-tone inputs up to +5 dBm 5 - 500 MHz dBm +38 — — Output IP3 Two-tone inputs up to +5 dBm 5 - 500 MHz dBm +28 — — Vbias — — VDC +14.5 +15.0 +15.5 Ibias Vbias = +15.0 VDC — mA — 50 60 Power Dissipation @ +15V Bias — mW — 750 — 2. All specifications apply when operated at +15 VDC, with 50 ohms source and load impedance. 3. Heat Sinking: Operation at case temperature above 95°C is not recommended. Heat sinking adequate to dissipate 850 mW must be provided in use. S11 S21 S12 S22 MAG ANG MAG ANG MAG ANG MAG ANG Frequency (MHz) S-Parameter Data
High Performance Amplifier, 17 dB Gain, 5 - 500 MHz AM-/AMC-147 Specifications subject to change without notice. n North America: Tel. (800) 366-2266 n Asia/Pacific: Tel.+81-44-844-8296, Fax +81-44-844-8298 n Europe: Tel. +44 (1344) 869 595, Fax+44 (1344) 300 020 Visit www.macom.com for additional data sheets and product information. V 3.00 Typical Performance Curves Noise Figure
Ordering Information
- Mounting kit part number AU00071 required for PCB applications. Part Number Package AM-147 PIN 4 TO-8-1 AMC-147 SMA Connectorized 1 dB Compression Intermodulation Intercept Gain vs. Frequency VSWR vs. Frequency 3 5 10 20 50 100 300 500 700 900 Frequency (MHz) Output Power (dBm) 3 5 10 20 50 100 300 500 700 900 Frequency (MHz) Gain (dB) 85°C 25°C -55°C 1.0 1.5 2.0 2.5 3 5 10 20 50 100 300 500 700 900 Frequency (MHz) VSWR RF IN RF OUT 3 5 10 20 50 100 300 500 700 900 Frequency (MHz) Noise Figure (dB) +85°C +25°C 3 5 10 20 50 100 300 400 500 700 900 Frequency (MHz) Intercept (dBm) IP2 (f1+f2) IP2 (f1-f2) IP3