AFBR-2310Z BOARDCOM | Alldatasheet

Document overview

  • Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
  • PDF pages: 7

Technical content

Features

 Compact package  Low dark current PIN  High-performance RF amplifier  FC single-mode fiber connectorized optical receptacle  Low power consumption  Flex interconnect to customer PCB  Minimal external circuitry required  RoHS6 compliant  Pairs to AFBR-1310Z, Fiber Optic Transmitter for Multi GHz analog links Specifications  Nominal 50Ω RF output impedance  3.3V RF amplifier and PIN bias voltage  200 V/W typical conversion gain  200-MHz to 5.5-GHz frequency range

Applications

 Analog optical links for satellite signal distribution  In-building antenna remote systems AFBR-2310Z Fiber-Optic Receiver for Multi GHz Analog Links

Table 1. Absolute Maximum Ratings is not implied, and damage to the device may occur. Table 2. Recommended Operating Conditions NOTE: Typical operating conditions are those values for which functional performance and device reliability is implied. Table 3. Electro-Optical Specifications NOTE: All O/E parameters refer to 1310-nm and 1550-nm wavelength optical input signals. 1600 nm, with reduced performance.

AFBR-2310Z Data Sheet Fiber-Optic Receiver for Multi GHz Analog Links Schematic Diagram Figure 1: Schematic Diagram RF amp6 RF Out FC optical connector PIN Light in

5 Ground

4 Ground

3 RF amp/PIN bias

2 RF amp/PIN bias

1 Ground

7 Ground

Figure 2: Electrical Pinout (Top View after 90° Bending of the Flexible PCB) Pad Function

AFBR-2310Z Data Sheet Fiber-Optic Receiver for Multi GHz Analog Links Broadcom AV02-3183EN

Package Information

The AFBR-2310Z Receiver is housed in a TO-46 header, joint to a robust FC plastic receptacle, as shown in Figure 3. Figure 4 shows the mechanical outline of the flex. A nut with washer is used to fix the receiver to the customer box wall. The aperture in the box wall should be designed to avoid rotation of the receptacle. A dust cap is provided for shipping and should be used whenever the receiver is not connected to a fiber patch cord. Figure 3: Mechanical Layout of Analog Receiver. The flex is shown before bending. All dimensions are in mm. ISO ( 5 : 1 ) 6.8 4.7 1.4 0.9 9.4 Area of flex board intended to be bent Pad layout pad # function pad 1 GND pad 2 Vcc pad 3 Vcc pad 4 GND pad 5 GND pad 6 RF out pad 7 GND pad 1

15.5 MAX

M8x0.75 FC-port according to IEC 61754-13 6.8 2.4 18.8 90°±4°

Broadcom, the pulse logo, Connecting everything, Avago Technologies, Avago, and the A logo are among the trademarks of Broadcom and/or its affiliates in the United States, certain other countries and/or the EU. Copyright © 2011–2018 Broadcom. All Rights Reserved. Broadcom reserves the right to make changes without further notice to any products or data herein to improve reliability, function, or design. Information furnished by Broadcom is believed to be accurate and reliable. However, Broadcom does not assume any liability arising out of the application or use of this information, nor the application or use of any product or circuit described herein, neither does it convey any license under its patent rights nor the rights of others.