DATASHEET SEARCH SITE | WWW.ALLDATASHEET.COM

Document overview

  • Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
  • PDF pages: 12

Technical content

Rev. C | Page 2 of 12 TABLE OF CONTENTS

REVISION HISTORY

5/12—Rev. B to Rev. C Changes to Features Section, General Description Section and Changes to 10 V Reference with Multiplying CMOS DACs or Changes to Precision DAC Reference Section and Figure 19... 10 7/01—Rev. A to Rev. B

Rev. C | Page 3 of 12 SPECIFICATIONS VIN = 15 V and 25°C, unless otherwise noted. Specifications shown in boldface are tested on all production units at final electrical test. Results from those tests are used to calculate outgoing quality levels. All minimum and maximum specifications are guaranteed; although, only those shown in boldface are tested on all production units. Table 1. AD584J AD584K Model Min Typ Max Min Typ Max Unit OUTPUT VOLTAGE TOLERANCE Maximum Error at Pin 1 for Nominal Outputs of

10.000 V ±30 ±10 mV

7.500 V ±20 ±8 mV

5.000 V ±15 ±6 mV

2.500 V ±7.5 ±3.5 mV OUTPUT VOLTAGE CHANGE Maximum Deviation from 25°C Value, TMIN to TMAX1 10.000 V, 7.500 V, and 5.000 V Outputs 30 15 ppm/°C

2.500 V Output 30 15 ppm/°C

Differential Temperature Coefficients Between Outputs 5 3 ppm/°C QUIESCENT CURRENT 0.75 1.0 0.75 1.0 mA Temperature Variation 1.5 1.5 µA/°C TURN-ON SETTLING TIME TO 0.1% 200 200 µs NOISE (0.1 Hz TO 10 Hz) 50 50 µV p-p LONG-TERM STABILITY 25 25 ppm/1000 Hrs SHORT-CIRCUIT CURRENT 30 30 mA LINE REGULATION (NO LOAD) 15 V ≤ VIN ≤ 30 V 0.002 0.002 %/V (VOUT + 2.5 V) ≤ VIN ≤ 15 V 0.005 0.005 %/V LOAD REGULATION 0 ≤ IOUT ≤ 5 mA, All Outputs 20 50 20 50 ppm/mA OUTPUT CURRENT VIN ≥ VOUT + 2.5 V Source at 25°C 10 10 mA Source TMIN to TMAX 5 5 mA Sink TMIN to TMAX 5 5 mA TEMPERATURE RANGE Operating 0 70 0 70 °C Storage −65 +175 −65 +175 °C PACKAGE OPTION 8-Pin Metal Header (TO-99, H-08) AD584JH AD584KH 8-Lead Plastic Dual In-Line Package (PDIP , N-8) AD584JN AD584KN 1 Calculated as average over the operating temperature range.

Rev. C | Page 4 of 12 Specifications shown in boldface are tested on all production units at final electrical test. Results from those tests are used to calculate outgoing quality levels. All minimum and maximum specifications are guaranteed; although, only those shown in boldface are tested on all production units. Table 2. AD584S AD584T Model Min Typ Max Min Typ Max Unit OUTPUT VOLTAGE TOLERANCE Maximum Error at Pin 1 for Nominal Outputs of 2.500 V ±7.5 ±3.5 mV OUTPUT VOLTAGE CHANGE Maximum Deviation from 25°C Value, TMIN to TMAX1 10.000 V, 7.500 V, and 5.000 V Outputs 30 15 ppm/°C

2.500 V Output 30 20 ppm/°C

Differential Temperature Coefficients Between Outputs 5 3 ppm/°C QUIESCENT CURRENT 0.75 1.0 0.75 1.0 mA Temperature Variation 1.5 1.5 µA/°C TURN-ON SETTLING TIME TO 0.1% 200 200 µs NOISE (0.1 Hz TO 10 Hz) 50 50 µV p-p LONG-TERM STABILITY 25 25 ppm/1000 Hrs SHORT-CIRCUIT CURRENT 30 30 mA LINE REGULATION (NO LOAD) 15 V ≤ VIN ≤ 30 V 0.002 0.002 %/V (VOUT + 2.5 V) ≤ VIN ≤ 15 V 0.005 0.005 %/V LOAD REGULATION 0 ≤ IOUT ≤ 5 mA, All Outputs 20 50 20 50 ppm/mA OUTPUT CURRENT VIN ≥ VOUT + 2.5 V Source at 25°C 10 10 mA Source TMIN to TMAX 5 5 mA Sink TMIN to TMAX 5 5 mA TEMPERATURE RANGE Operating −55 +125 −55 +125 °C Storage −65 +175 −65 +175 °C PACKAGE OPTION 8-Pin Metal Header (TO-99, H-08) AD584SH AD584TH 1 Calculated as average over the operating temperature range.

Rev. C | Page 5 of 12 ABSOLUTE MAXIMUM RATINGS Table 3. Parameter Rating Input Voltage VIN to Ground 40 V Power Dissipation at 25°C 600 mW Operating Junction Temperature Range −55°C to +125°C Lead Temperature (Soldering 10 sec) 300°C Thermal Resistance Junction-to-Ambient (H-08A) 150°C/W Stresses above those listed under Absolute Maximum Ratings may cause permanent damage to the device. This is a stress rating only; functional operation of the device at these or any other conditions above those indicated in the operational section of this specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability. ESD CAUTION

within the error band from 0°C to 70°C (that is, J and K grades). Figure 6. Typical Temperature Characteristic

0 V output) is about 28 mA; however, when shorted to 15 V , the

sink current goes to approximately 20 mA. Figure 7. Output Voltage vs. Output Current (Sink and Source) turn-on waveform after an extended period with the supplies off. 180 µs, and there is no long thermal tail appearing after the point. Figure 8. Output Settling Characteristic

obtain outputs above 5.0 V . Figure 13. NPN Output Current Booster with the insertion of a single external resistor (see Figure 14). The minimum voltage required to drive the connection is 5 V . Figure 14. A Two-Component Precision Current Limiter and 5 mA (between 2 mA and 5 mA for operation beyond 85°C). Figure 15. 2-Terminal, −5 V Reference 5 mA (2 mA to 5 mA for operation beyond 85°C).

10 V REFERENCE WITH MULTIPLYING CMOS DACs

multiplying CMOS DAC, especially for low power applications. supply current is typically 2 mA. Figure 16. Low Power 10-Bit CMOS DAC Application

to give a 0 V to +10 V ADC range. This is shown in Figure 17. found in the data sheets for the CMOS products. Figure 17. AD584 as −10 V Reference for CMOS ADC applied to another popular digital-to-analog configuration. Figure 18. Current Output, 8-Bit Digital-to-Analog Configuration Figure 19. Precision 12-Bit DAC

6 OP AMP

Rev. C | Page 12 of 12 ORDERING GUIDE Model1 Output Voltage (VO) Initial Accuracy Temperature Coefficient (ppm/°C) Temperature Range (°C) Package

Description

Quantity mV % AD584JH 2.5 ±7.5 0.30 30 0 to 70 8-Pin TO-99 H-08 100 AD584JNZ 2.5 ±7.5 0.30 30 0 to 70 8-Lead PDIP N-8 50 AD584KH 2.5 ±3.5 0.14 15 0 to 70 8-Pin TO-99 H-08 100 AD584KNZ 2.5 ±3.5 0.14 15 0 to 70 8-Lead PDIP N-8 50 AD584SH 2.5 ±7.5 0.30 30 −55 to +125 8-Pin TO-99 H-08 100 AD584SH/883B 2.5 ±7.5 0.30 30 −55 to +125 8-Pin TO-99 H-08 100 AD584TH 2.5 ±3.5 0.14 20 −55 to +125 8-Pin TO-99 H-08 100 AD584TH/883B 2.5 ±3.5 0.14 20 −55 to +125 8-Pin TO-99 H-08 100 AD584JH 5.0 ±15.0 0.30 30 0 to 70 8-Pin TO-99 H-08 100 AD584JNZ 5.0 ±15.0 0.30 30 0 to 70 8-Lead PDIP N-8 50 AD584KH 5.0 ±6.0 0.12 15 0 to 70 8-Pin TO-99 H-08 100 AD584KNZ 5.0 ±6.0 0.12 15 0 to 70 8-Lead PDIP N-8 50 AD584SH 5.0 ±15.0 0.14 30 −55 to +125 8-Pin TO-99 H-08 100 AD584SH/883B 5.0 ±15.0 0.30 30 −55 to +125 8-Pin TO-99 H-08 100 AD584TH 5.0 ±6.0 0.30 15 −55 to +125 8-Pin TO-99 H-08 100 AD584TH/883B 5.0 ±6.0 0.12 15 −55 to +125 8-Pin TO-99 H-08 100 AD584JH 7.5 ±20.0 0.27 30 0 to 70 8-Pin TO-99 H-08 100 AD584JNZ 7.5 ±20.0 0.27 30 0 to 70 8-Lead PDIP N-8 50 AD584KH 7.5 ±8.0 0.11 15 0 to 70 8-Pin TO-99 H-08 100 AD584KNZ 7.5 ±8.0 0.11 15 0 to 70 8-Lead PDIP N-8 50 AD584SH 7.5 ±20.0 0.27 30 −55 to +125 8-Pin TO-99 H-08 100 AD584SH/883B 7.5 ±20.0 0.27 30 −55 to +125 8-Pin TO-99 H-08 100 AD584TH 7.5 ±8.0 0.11 15 −55 to +125 8-Pin TO-99 H-08 100 AD584TH/883B 7.5 ±8.0 0.11 15 −55 to +125 8-Pin TO-99 H-08 100 AD584JH 10.0 ±30.0 0.30 30 0 to 70 8-Pin TO-99 H-08 100 AD584JNZ 10.0 ±30.0 0.30 30 0 to 70 8-Lead PDIP N-8 50 AD584KH 10.0 ±10.0 0.10 15 0 to 70 8-Pin TO-99 H-08 100 AD584KNZ 10.0 ±10.0 0.10 15 0 to 70 8-Lead PDIP N-8 50 AD584SH 10.0 ±30.0 0.30 30 −55 to +125 8-Pin TO-99 H-08 100 AD584SH/883B 10.0 ±30.0 0.30 30 −55 to +125 8-Pin TO-99 H-08 100 AD584TH 10.0 ±10.0 0.10 15 −55 to +125 8-Pin TO-99 H-08 100 AD584TH/883B 10.0 ±10.0 0.10 15 −55 to +125 8-Pin TO-99 H-08 100 1 Z = RoHS Compliant Part. ©1978–2012 Analog Devices, Inc. All rights reserved. Trademarks and registered trademarks are the property of their respective owners. D00527-0-5/12(C)