9820-05-UK MULTICOMP | Alldatasheet
Document overview
- Manufacturer or author: Provided By alldatasheet.com(free datasheet download site)
- PDF pages: 3
Technical content
www.element14.com www.farnell.com www.newark.com Page <1> V1.011/09/12 Adaptor Specifications: Environmental Requirements: Operating temperature : 0°C to 40°C Storage temperature : -25°C to +85°C Operating humidity : 30% to 95% Storage humidity : 30% to 98% Operating bar : 1bar Input Requirements: Regular input voltage : 100V AC to 240V AC Variable input voltage range : 90V AC to 264V AC Rating frequency : 50Hz to 60Hz Frequency range : 47Hz to 63Hz Input current : 0.18Arms maximum (at regular voltage and current) Introduction of AMP9820: The SMPS operated at input regular voltage 100Vt AC to 240V AC The SMPS should be capable of a total continuous DC power output of 7.5 watts The SMPS should be capable of a total peak 10 watts The SMPS should be able to single output only The SMPS should not be fired or emitted smoke by protection when the circuit is short The SMPS should carried maximum power when the output circuit is short that the unit is really hot DC Insulation Resistance: Input - output : 50MΩ minimum (at 500V DC) Input - body metal : 50MΩ minimum (at 500V DC) Dielectric Withstand - Voltage: Input - output : 3750V AC minimum for (1 minute) Input - body metal : 3750V AC minimum for (1 minute) Main Fuse: Input fuse is 10Ω, 1W fusible resistor
www.element14.com www.farnell.com www.newark.com Page <2> V1.011/09/12 Adaptor Rated Output (V) 5 6 7.5 9 12 15 Peak Load Current (A) 2 1.5 0.9 0.7 Short Output Current (A) 3 Ripple and Noise (mV) 35 50 80 100 Over Voltage Protection No Over Heat Protection Yes Rated Power (W) 7.5 7.8 9 Peak Power (W) 10 Switch Frequency (KHz) 130 Insulation Class II Consumes (W) < 0.2 Inrush Current: Peak inrush current shall be limited to 10A for a cold start Time Sequence: Time sequence should be satisfied to power ON/OFF AC switch at ON/OFF: Output Rated and Electrical Specifications Efficiency: The efficiency of the SMPS must be satisfied the minimum 70%
www.element14.com www.farnell.com www.newark.com Page <3> V1.011/09/12 Adaptor Description Part Number Adaptor, Reg, 5V DC, 1.5A 9820-05-UK Adaptor, Reg, 6V DC, 1.3A 9820-06-UK Adaptor, Reg, 7.5V DC, 1.2A 9820-075-UK Adaptor, Reg, 9V DC, 1A 9820-09-UK Adaptor, Reg, 12V DC, 700mA 9820-12-UK Adaptor, Reg, 15V DC, 550mA 9820-15-UK Important Notice : This data sheet and its contents (the “Information”) belong to the members of the Premier Farnell group of companies (the “Group”) or are licensed to it. No licence is granted for the use of it other than for information purposes in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change without notice and replaces all data sheets previously supplied. The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness, any error in or omission from it or for any use made of it. Users of this data sheet should check for themselves the Information and the suitability of the products for their purpose and not make any assumptions based on information included or omitted. Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from negligence or where the Group was aware of the possibility of such loss or damage arising) is excluded. This will not operate to limit or restrict the Group’s liability for death or personal injury resulting from its negligence. Multicomp is the registered trademark of the Group. © Premier Farnell plc 2012. Dimensions : Millimetres Part Number Table