408-4375 TEC | Alldatasheet
Document overview
- Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
- PDF pages: 1
Technical content
1 of 1E2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company All Rights Reserved *Trademark TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners. TOOLING ASSISTANCE CENTER 1-- 800-- 722-- 1111 PRODUCT INFORMATION 1- -800- -522- -6752 This controlled document is subject to change. For latest revision and Regional Customer Service, visit our website atwww.te.com
21 APR 11 Rev AExtraction Tool 318837- 1
- INTRODUCTION Extraction Tool 318837- -1, shown in Figure 1, is designed to remove the .093 Commercial Pin and Socket contacts listed in Figure 2 from connector housings. Read these instructions thoroughly before attempting to remove any contacts. .093 COMMERCIAL PIN AND SOCKET CONTACT BASE PART NUMBER STRIP- -FORM LOOSE- -PIECE 350415 350416 350417 350418 770383 770385 770529 770530 770815 770144 770145 770146 770147 Figure 2 2. DESCRIPTION(Figure 1) The extraction tool consists of a spring- -loaded metal tip with an integral plunger mounted to a plastic handle with an interlock lever. When the interlock lever is depressed, the plunger is held until the contact locking lances are depressed by the tip. After the lever is released, the plunger is released, permitting the contact to be pushed out the rear of the housing. 3. EXTRACTION PROCEDURE(Figure 3) 1. Determine the contact to be removed and grasp the wire attached to that contact. 2. Move the contact forward as far as possible by pushing the wire toward the housing. If pushing the wire by hand is difficult, use Insertion Tool 91002- -1. 3. Depress the extraction tool interlock lever and insert the tip of the tool into the contact cavity in the mating face of the housing. Make sure that the tip is completely bottomed in the cavity. Figure 3 Mating Face of Housing (Ref) Push Wire Toward Housing Before Engaging Tool Tip Interlock Lever Depressed 4. While holding the extraction tool in position and pulling back on the wire, release the interlock lever and push the tool handle forward. The wire and contact should pull out of the housing. Before using the contact again, reset the locking lances to their original positions. To obtain the correct setting dimensions for the locking lances, consult the Customer Drawing covering the specific contact, or contact TE Connectivity Engineering. 4. TOOL MAINTENANCE It is recommended that the tool be inspected when you receive it and at regularly scheduled intervals. The tool is not repairable and should be replaced when it is worn or damaged. Store the extraction tool in a clean, dry place and clean the extraction tool with a soft, lint- -free cloth. Additional tools can be purchased from: CUSTOMER SERVICE (38- -25) TYCO ELECTRONICS CORPORATION PO BOX 3608 HARRISBURG PA 17105- -3608 5. REVISION SUMMARY S Updated document to corporate requirements S New logo ORIGINAL INSTRUCTIONS NOTE i NOTE i