2157626 WAGO | Alldatasheet
Document overview
- Manufacturer or author: Provided By alldatasheet.com(free datasheet download site)
- PDF pages: 1
Technical content
10 20 30 40 50 60 70 80 90 100 1050 Material data: Material group I Insulating material Polyamide 66 (PA 66) Flammability class per UL 94 V0 Lower/Upper limit temperature -60 °C / +100 °C / Press-in pin: -40 °C / +85 °C Contact material Electrolytic copper (ECu) / Copper alloy for press-in technology Contact plating tin-plated MCS connectors are also available upon request with gold-plated or partially gold-plated contact surfaces. Additional approvals and corresponding ratings can be found at www.wago.com. For additional technical information, see Section 13. MCS MICRO accessory Page: Coding keys 235 Male Headers with Solder and Press-In Pins, MCS-MIDI Pin Spacing: 2.5 mm MCS MICRO Solder and press-in pin data: Solder pin: length/width 4.6 mm / 0.8 x 0.8 mm (straight) Solder pin: length/width 3.7 mm / 0.8 x 0.8 mm (angled) Solder pin: drilled hole diameter 1.1+0.1 mm Press-in pin: length/width 3.2 mm / 0.6 x 1.2 mm Press-in pin: drilled hole diameter 1.15±0.025 mm Press-in pin: metal-plated hole 1.0 mm (HAL Sn) Press-in pin: metal-plated hole 1.0 –0.00 mm (Chem. Sn) Technical data: Pin Spacing 2.5 mm / 0.098 in. Press-In Technology 2.5 mm / 0.098 in. Ratings per IEC/EN 60664-1 IEC/EN 60664-1 Overvoltage category III III II III III II Pollution degree 3 2 2 3 2 2 Rated voltage 80 V 160 V 320 V 80 V 160 V 320 V Nominal current 6 A 6 A 6 A 4 A 4 A 4 A Approvals per UL/CSA UL/CSA Use group UL 1059 B C D B C D Rated voltage 150 V – – 150 V – – Nominal current UL 4 A – – 4 A – – Nominal current CSA 4 A – – 4 A – – Derating Curve Ambient operating temperature in °C Current in A Conductor rated current 733-102 female connector with 733-362 male header Pin spacing: 2.5 mm / Conductor size: 0.5 mm2 “f-st” Based on: EN 60512-5-2 / Reduction factor: 0.8
- Horizontal or vertical PCB mounting via straight and angled solder pins
- Also available with press-in pins for solder-free connection to the PCB
- 100 % protected against mismating; only mating halves with the same pole number can be connected together
- Coding pins available The MULTI CONNECTION SYSTEM (MCS) is designed without breaking capacity for compliance with DIN EN 61984. When used as intended, these connectors shall not be connected/disconnected when live or under load. The circuit design should ensure header pins, which can be touched, are not live when unmated.