62201-8630 MOLEX | Alldatasheet
Document overview
- Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
- PDF pages: 3
Technical content
Press-In Tool for I-Trac™ Power Module Assembly Doc No: ATS-622018630 Release Date: 04-16-07 UNCONTROLLED COPY Page 1 of 3 Revision: C Revision Date: 11-30-10 I-Trac™ Vertical Power Module Installation (Right Angle) Press-In Tool Application Tooling Specification Sheet Order No. 62201-8630
FEATURES
/square4 Vertical Power Module must be installed separately /square4 Use as a stand-alone tool or mounted in an optional holder with other Molex press-in tools. /square4 Guide surface provided for positive alignment to co nnector assembly /square4 Tool provides uniform distribution of press force a cross entire pin array SCOPE Products : I-Trac™ Vertical Power Module Assembly 78227 Ser ies, 7 Row Assemblies. See Product List below for specific part numbers. Product List The following is a partial list of the product orde r numbers and their specifications this tool is des igned to run. Updates to this list are available on www.molex.com Vertical Power Module Series Number Row Assembly Order Number 78227 7 78227-1001 78227-5001 Tool Setup Depending on the number of connectors to be install ed and/or the press used, this tool can be used as a stand- alone or with a group of press-in tools, mounted in a 62201-95XX rail (ordered separately). See Figur e 1. WITH 62201-95XX RAIL Figure 1 ALONE PRESS-IN TOOL POWER MODULE PRESS-IN TOOL POWER MODULE GUIDE SUFACES GUIDE SUFACES
Press-In Tool for I-Trac™ Power Module Assembly Doc No: ATS-622018630 Release Date: 04-16-07 UNCONTROLLED COPY Page 2 of 3 Revision: C Revision Date: 11-30-10 Tool Installation The 62201-95XX rail is available in a variety of le ngths to accommodate multiple press-in tools. Rail Part Number Rail Overall Length 62201-9501 24mm (0.94 in) 62201-9502 72mm (2.83 in) 62201-9503 156mm (6.14 in) 62201-9504 216mm (8.50 in) 62201-9509 254mm (10.0 in) 62201-9511 305mm (12.0 in) Printed Circuit Board (PCB) Support The I-Trac™ connectors require up to 6.0kg (13.2 lb s) of force per pin to press into the PCB. To prev ent flexing or damage to the PCB, a support plate is strongly reco mmended directly beneath the connector terminal hol e pattern. Due to the custom nature of every application, a bo ard support is required for proper tool application . This can be supplied by the customer or by Molex. For more inf ormation contact Molex Application Tooling. When creating a PCB support plate, allow clearance for connector terminal pins that pass through the P CB. Press Equipment Recommendations Many types of presses can be used to install I-Trac ™ connectors, but to assure consistent connector in stallation Molex recommends the following press criteria: 1. The capability to detect force variations as low as 4.5kg (10 lb) during the press-in cycle; excessive force measurements should stop the press-in cycle. 2. The rate of pressing can be regulated as low as 0.1 3mm (0.005 in) per second. 3. Press stroke control to within 0.25mm (0.010 in). 4. Total press stroke must be at least 19mm (0.75 in). 5. For statistical purposes, automatic collection of f orce and distance data.