6173 BITECH | Alldatasheet

Document overview

  • Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
  • PDF pages: 3

Technical content

BI Technologies Corporation

4200 Bonita Place, Fullerton, CA 92835 USA

Phone: 714 447 2345 Website: www.bitechnologies.com 7/8” D iam eter Single Turn Conductive Plastic Precision Potentiom eter / Position Sensor M odel 6173 Total Mechanical Travel 360° continuous Number of Gangs 4 maximum Weight 0.92 oz. single gang nominal, 0.6 oz. each added gang Shaft Runout maximum T.I.R. 0.001” Pilot Diameter Runout maximum T.I.R. 0.001” Lateral Runout maximum T.I.R. 0.002” Shaft Radial Play maximum 0.001” Start/Run Torque maximum 0.5 oz.-in. per gang M ECHANICAL ELECTRICAL 1 1 Specifications subject to change without notice. 2 Linearity is measured between 1% and 99% of input voltage. 3 Special TCR available to ±100 ppm/°C. 4 Measured with 10 VDC CW to CCW and slider at 50% of electrical travel. Resistance Range 1K to 100K Ohms Standard Resistance Tolerance ±10% Minimum Practical Resistance Tolerance ±5% Independent Linearity 2 ±1% Minimum Practical Independent Linearity ±0.25% Input Voltage 400 VDC maximum, not to exceed power rating Power Rating 1.0 Watt at 70°C, derating to 0 at 125°C Dielectric Strength 1,000 V rms Insulation Resistance 1,000 Megohms minimum Output smoothness 0.1% maximum Actual Electrical Travel 335° nominal Electrical Continuity Travel 346° minimum End Voltage maximum 0.5% of input voltage Resolution essentially infinite Temperature Coefficient of Resistance 3 -400 ppm/°C typical Temperature Coefficient of Output Voltage 4 ±10 ppm/°C typical October 31 2014 Model 6173 page 1 of 3 RoH S 2 com pliant Pb

BI Technologies Corporation Phone: 714 447 2345 Website: www.bitechnologies.com Operating Temperature Range -40°C to +125°C dynamic, -65°C to +125°C static Temperature Cycling 5 cycles, -65°C to +125°C, maximum 10% ΔR Shock 6 ms Saw-tooth, 100 G’s, 0.1 ms maximum discontinuity Vibration 15 G’s, 10 to 500 Hz, maximum 2% ΔR, 0.1 ms maximum discontinuity Moisture Resistance ten 24 hour cycles, maximum 10% ΔR High Temperature Exposure 1,000 hours at 125°C, maximum 0.5% ΔR Rotational Life 25 million shaft revolutions Rotational Load Life 5 million shaft revolutions at 1.0 Watt & 70°C plus 900 hours at 1.0 Watt, maximum 10% ΔR Ingress Protection Rating (IP Code) IP50 ENVIRONM ENTAL (M IL-PRF-39023) ORDERING INFORM ATION Model Series Resistance Prefix Resistance Value Optional Feature Code (see table) Optional Non-standard Tolerance 6173 R 10K T5 L.5 xx FEATURE CODES M odel 6173 Linearity (CCW) (S) (CW) CIRCUIT DIAGRAM STANDARD RESISTANCE VALUES 1K 2K 5K 10K 20K 50K October 31 2014 Model 6173 page 2 of 3 Center Tap CT Linearity Tape LT Flatted Shaft FS Slotted Shaft SS Rear Shaft Extension RS Additional Gangs 2G, 3G, or 4G When multiple Optional Feature codes are used the P/N shall be in the same sequence as listed in this table (top to bottom).

BI Technologies Corporation Phone: 714 447 2345 Website: www.bitechnologies.com M odel 6173 OUTLINE DRAW ING Clamp Ears CW CCW Slider 105° Max. .625 15.9 R. Max. "RS" ±.016 ±0.41 "L" ±.010 ±0.25 Mounting Surface .500±.031 12.7±0.79 +.0000 -.0003 +0.000 -0.008 .1248 3.1699 +.0000 -.0005 +0.000 -0.0127 .7500 19.050 Dia. Dia. .875±.005 22.6±0.41 Dia. .781 19.8 Max. .062±.005 1.58±0.13 .062±.005 1.58±0.13 Chamfer .016 0.41 Max. x 45° .010 0.25 R. Max. .062±.005 1.58±0.13 .160 4.06 Min. Dim. “L” Dim. “RS” No. of Gangs .500 12.7 .850 21.59 1.200 30.48 1.550 39.70 1.000 25.40 1.350 34.29 1.700 43.18 2.050 52.07 October 31 2014 Model 6173 page 3 of 3