DATASHEET SEARCH SITE | WWW.ALLDATASHEET.COM
Document overview
- Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
- PDF pages: 1
Technical content
CAGE Code 06324©2011 Glenair, Inc. Printed in U.S.A. Series 72 Guardian GLENAIR, INC. • 1211 AIR WAY • GLENDALE, CA 91201-2497 • 818-247-6000 • FAX 818-500-9912 BAnd-it® Shield termination System How to order Bands Band Type Width Length Part Number Use With Tool Accomodates Dia. 1. Prepare Cable Braid for termination process (Figure 1). 2. Push Braid forward over Adapter Reten- tion Lip to the Adapter Incline Point (or .4" [10.2mm] minimum braid length). Milk Braid as required to remove slack and insure a snug fit around the shield termination area (Figure 2). 3. Prepare the Band in the following manner: IMPORTANT: Due to Connector/Adapter circumference, it may be necessary to prepare the Band around the Cable or Retention Area. A. Roll Band through the Buckle Slot twice. (Bands must be double-coiled.) B. Pull on Band until Mark ( ) is within approximately .250 inch (6.4mm) of Buckle Slot (Figure 3). The Band may be tightened further if desired. nOtE: Prepared band should have ( Mark visible approximately where shown in Figure 3. Shield Termination Clamping Process (Figures 4 thru 8) NOTE: To free Tool Handles, move Holding Clips to center of Tool. 4. Squeeze Gripper Release Lever and insert Band into the front end opening of the Tool. (NOTE: Circular portion of looped band must always face downward.) 5. Aligning the Band and Tool with the Shield Termination Area, squeeze Black Pull-Up Handle repeatedly using short strokes until it locks against Tool Body. (This indicates the Band is compressed to the Tool Preca- librated Tension.) NOTE: If alignment of band and shield is unsatisfactory, tension on band can be relaxed by pushing on slotted release lever on top of tool. Make adjustments as necessary and again squeeze black pull-up handle. 6. Complete the Clamping Process by squeez- ing the Gray Cut-Off Handle. 7. Remove excess band from tool and dispose. 8. Inspect Shield Termination. BAND-IT® Shield Termination Instructions Buckle Tail Length Indicator mark Adapter retention Lip Conductors Braid Adapter Incline .400 (1.2mm) min. Length Braid Over Termination Area BAND-IT® shield termination system Fast, Cost-Effective Shield termination Attach cable braid shields to EMI backshells with BAND-IT® stainless steel straps. The BAND-IT® system offers fast termination and the flexibility to handle different diameters with the same band. iMPORtant nOtE: aLWaYS dOUbLE-WRaP bandS! Contact Glenair or visit our website (glenair.com) to view our complete line of BAND-IT® products, including pneumatic tools for high production and calibration kits. Micro Band Tool Part Number 600-061 Standard Band Tool Part Number 600-058 1.18 lbs. / 6.75 Inches (172mm.) Length