DATASHEET SEARCH SITE | WWW.ALLDATASHEET.COM
Document overview
- Manufacturer or author: Provided By www.digicamel.com(FREE DATASHEET DOWNLOAD SITE)
- PDF pages: 12
Technical content
Features
Frequency: 3400–3800 MHz 3.3 V or 5 V supply for RF amplifier P1dB: 25 dBm @ 3600 MHz, VCC2 =3 . 3V d c P1dB: 29 dBm @ 3600 MHz, VCC2 =5V d c Power consumption: –1 1 4m W@VCC2 =3 . 3V d c – 168 mW @ VCC2 =5V d c Fully matched (50 ohm input/output, DC blocked) Compact 4 mm 3 mm LGA package Figure 1. Functional Block Diagram
Table 1. Maximum Ratings Table 2. ESD Protection Characteristics Table 3. Moisture Sensitivity Level Table 4. Electrical Characteristics(VCC1 =3 . 3 V d c , VCC2 = 5 Vdc, 3500 MHz, TA =2 5C, 50 ohm system, in NXP Application Circuit) Table 5. Ordering Information
Figure 2. Pin Connections Table 6. Functional Pin Description
3 RFin RF Input
5 EN Bias Enable/Disable
6 LLS Logic Level Select
7 VCC1 Power Supply for Controller
9 RFout RF Output
14 VCC2 Power Supply for the RF Pre- -driver
Figure 3. AFLP5G35645 Application Circuit Component Layout Table 7. AFLP5G35645 Application Circuit Designations and Values
- Set VCC1 to 3.3 V, VCC2 t o5V
- Apply RF input power to desired level
Refer to the following resource to aid your design process. Development Tools Printed Circuit Boards FAILURE ANALYSIS At this time, because of the physical characteristics of the part, failure analysis is limited to electrical signature analysis. In cases where NXP is contractually obligated to perform failure analysis (FA) services, full FA may be performed by third party vendors with moderate success. For updates contact your local NXP Sales Office.
REVISION HISTORY
The following table summarizes revisions to this document. Revision Date Description 0 Oct. 2019 Initial release of data sheet 1 Jan. 2020 Component layout PCB device file updated to reflect VCC2 etching. Board revision number and MTL number updated, p. 4
Document Number: AFLP5G35645 Rev. 1, 01/2020 Information in this document is provided solely to enablesystem and software implementers to use NXP products. There are no express or implied copyright licenses granted hereunder to design or fabricate any integrated circuits based on the information in this document. NXP reserves the right to make changes without further notice to any products herein. NXP makes no warranty, representation, orguarantee regarding the suitability of its products for any particularpurpose, nor does NXP assume any liability arising out of the application or use of any product or circuit, andspecifically disclaims any and all liability, including without limitation consequential or incidental damages. “Typical” parameters that may be provided in NXP data sheets and/or specifications can and do vary in different applications, and actual performance may vary over time. All operating parameters, including “typicals,” must be validated for each customer application by customer’s technical experts. NXP does not convey any license under its patent rights nor the rights of others. NXP sells products pursuant to standard terms and conditions of sale, which can be found at the following address:nxp.com/ SalesTermsandConditions. NXP, the NXP logo and Airfast are trademarks of NXP B.V. All other product or service names are the property of their respective owners. E 2019–2020 NXP B.V. How to Reach Us: Home Page: nxp.com Web Support: nxp.com/support