DATASHEET SEARCH SITE | WWW.ALLDATASHEET.COM
Document overview
- Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
- PDF pages: 2
Technical content
Instruction SheetSMPM Floating Panel Mount, Cable Jacks (Direct Solder Attachment) 408- -10373 LOC B 1 of 2E2010 Tyco Electronics Corporation, Berwyn, PA All Rights Reserved TE logo and Tyco Electronics are trademarks. *Trademark. Other products names, logos, or company names might be trademarks of their respective owners. TOOLING ASSISTANCE CENTER 1- -800- -722- -1111 PRODUCT INFORMATION 1- -800- -522- -6752 This controlled document is subject to change. For latest revision and Regional Customer Service, visit our website atwww.tycoelectronics.com
06 AUG 10 Rev B1996390- 1, 1996771- 1
- INTRODUCTION SMPM Floating Panel Mount Cable Jacks (Direct Solder Attachment) shown in Figure 1 are designed to be soldered to semi- -rigid, conformable, or flexible coaxial cable with a diameter of 2.16 mm [.085 in.] or 1.19 mm [.047 in.] The cable jacks are designed to be inserted into a mounting hole (such as the one in VITA 67, daughter card module 1996705- -3). Dimensions in this instruction sheet are in millimeters [with inches in brackets]. Figures and illustrations are for reference only and are not drawn to scale. 2. DESCRIPTION The cable jacks consists of a body, compression spring, retaining washer, and center contact. The compression spring and retaining washer are used to secure the part into the module. See Figure 1. 3. ASSEMBLY PROCEDURE 1. Strip the cable to the dimensions shown in Figure 2. DO NOT nick the center conductor of the cable. Take care not to cut the cable braid. 2. For flexible cable, tin the cable braid. 3. Shape the blunt end of the center conductor to a cone between 85 and 90. See Figure 3. 4. Insert the cable center conductor into the center contact inside the rear shell of the cable plug until the cable bottoms. No braid strands should be exposed. See Figure 4. 5. Holding the cable center conductor in place and using 60/40 solder, attach the rear shell to the cable as shown in Figure 4. Figure 2 Center Conductor Semi- -Rigid and Conformable Cables Flexible Cable Stripping Dimensions 80+10_ Typ 0.25 [.010] Max Typ Flat (Radius Optional) 2.03 [.080] Outer Conductor 5.33 [.210] Braid Jacket Center Conductor 2.03 [.080] Figure 3 Cable Center Conductor 85- -90_ Figure 4 Solder Here Cable To avoid personal injury, make sure to follow all local practices and safety precautions when working with soldering equipment. 4. INSERTING CONNECTOR INTO MODULE 1. Insert soldered cable connector into module mounting hole from the flange side of the module bottoming the connector body flange on the module. See Figure 5. NOTE i CAUTION DANGER