DATASHEET SEARCH SITE | WWW.ALLDATASHEET.COM
Document overview
- Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
- PDF pages: 3
Technical content
For 2.16 [.085] Cable For 3.58 [.141] Cable For 1.78 [.070] Cable 408-8783 3 of 3Rev A Figure 4 5. USING SOLDER GAGES AND CENTER CONTACT HOLDER The center contact holder is designed to hold both male and female connector center contacts. Solder gages are used to properly space the center co ntact away from the cable dielectric. Refer to the connector specific instruction sheet for the appropriate solder gage to be used during the assembly procedure. CAUTION Center contact holders contains small amounts of lead. The lead is used for assembly. NOTE i Maximum operating temperature for the center contact holder is 300°C [572°F] DANGER STOP T o avoid personal injury, be sure to observe all local safety practices (including the use of gloves). The solde r gage, center contact holder, and the contact may be hot after soldering. 6. USING LOCATING TOOLS Solder Assembly Kit 1055469-1 contains two locating tools. Refer to the connector specific instruction sheet for selection of proper locator tool and assembly instructions. These tools are designed to be used with the fixture subassembly. To insure proper connector assembly, follow the instructions listed below. 1. Place connector housing on end of cable sub- assembly. The subassembly refers to cable with center contact. 2. Place loose connector assembly in fixture base. 3. Nest the center contact in locator tool. 4. Tighten the thumbscrew to secure t he cable. 5. Tighten the locator tool to seat th e cable firmly. 6. Slide connector housing over locator tool. 7. Maintain position of hous ing firmly against locator tool. DANGER STOP T o avoid personal injury, be sure to follow all local safety practices when using solder and solder equipment. 8. Solder according to the connector specific instruc tions. NOTE i Fixture should be clamped vertically in vise to keep housing seated against locator tool. 7. REVISION SUMMARY Revisions to this instruction sheet include:
- Changed company name and logo