030-0005 MULTICOMP | Alldatasheet
Document overview
- Manufacturer or author: Provided By alldatasheet.com(free datasheet download site)
- PDF pages: 1
Technical content
Page <1> V1.007/06/22 Antistatic Storage Pin-Thumb Tak Newark.com/multicomp-pro Farnell.com/multicomp-pro sg.element14.com/b/multicomp-pro Important Notice : This data sheet and its contents (the “Information”) belong to the members of the AVNET group of companies (the “Group”) or are licensed to it. No licence is granted for the use of it other than for information purposes in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change without notice and replaces all data sheets previously supplied. The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness, any error in or omission from it or for any use made of it. Users of this data sheet should check for themselves the Information and the suitability of the products for their purpose and not make any assumptions based on information included or omitted. Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from negligence or where the Group was aware of the possibility of such loss or damage arising) is excluded. This will not operate to limit or restrict the Group’s liability for death or personal injury resulting from its negligence. Multicomp Pro is the registered trademark of Premier Farnell Limited 2019. Part Number Table Description Part Number Antistatic Storage, Pin-Thumb Tak, Tube, 8mm, 25.4mm 030-0005 Specifications ESD Storage Type : Tube External Height : 8mm External Width : 25.4mm Controls for Antistatic Tube The standard used by ITW for testing antistatic tubes is the American National Standard ANSI/EIA-541-1988. Packaging material standards for ESD sensitive items. Condition Controls The machine used is an ETS 405D Static Decay Meter Humidity control chamber The tubes are conditioned for 48 hours in a control chamber at 12% RH, which is more stringent than EIA 541 requirements of 15% RH. A static decay test on the tube is carried out by putting a surface charge of 5000 volts on the tube which should dissipate in less than 2z. ITW product averages 0.5s. decay time. The same test is made 3 times on the spositive side and nagative. The results are within 0.02 seconds to pass the test. Decay results of each daily production are recorded and are available on request. Resistivity Control The machine is an ETS 806 Surface resistivity meter The technical specification for anti-static tubes is >1×10e6 and <1×10e12 ITW average products 1×10e9 Antistatic Solution Control The antistatic solution is tested once a day for conductivity and alcohol content. Production Control Hourly inspection Samples of each batch are kept on the shelf for 6 months.
Description
This product is a Pin Thumb Tak for IC tubes.