SW05-0311 MACOM
Document overview
- Manufacturer or author: Provided By www.digicamel.com(FREE DATASHEET DOWNLOAD SITE)
- PDF pages: 3
Technical content
Features
n Low DC Power Consumption n Surface Mount Package n Low Cost/High Performance n 50 Ohm Nominal Impedance
Description
M/A-COM’s SW05-0311 is a GaAs FET SPST absorptive switch with integral silicon ASIC driver. Packaged in a 16-lead c eramic surface mount package, this device offers excellent performance and repeatability from DC to 3 GHz while maintaining low power consumption. The SW05-0311 is ideally suited for use where fast speed, low power consumption and broadband applications a re required. Electrical Specifications1,2 TA = +25°C Parameter Test Conditions Frequency Units Min Typ Max Insertion Loss — DC - 3000 MHz DC - 2000 MHz DC - 1000 MHz DC - 500 MHz dB dB dB dB 1.0 0.8 0.7 0.6 1.3 1.2 1.0 0.8 VSWR — DC - 3000 MHz DC - 2000 MHz DC - 1000 MHz DC - 500 MHz Ratio Ratio Ratio Ratio 1.4:1 1.3:1 1.2:1 1.1:1 1.5:1 1.4:1 1.3:1 1.2:1 Isolation — DC - 3000 MHz DC - 2000 MHz DC - 1000 MHz DC - 500 MHz dB dB dB dB Trise, Tfall 10% to 90% — ns — 50 — Ton, Toff D1.3V CTL to 90% / 10% — ns — 150 — Transients In-Band — mV — 50 — 1 dB Compression Input Power 0.05 GHz
0.5 GHz to 3 GHz
+21 +27 IP2 Two-Tone Input Power up to +5 dBm
0.05 GHz
+62 +68 IP3 Two-Tone Input Power up to +5 dBm +40 +46 Vin Low 0V to 0.8V — µA — — 1 Vin High 2.0V to 5.0V — µA — — 1 1. All specifications apply when operated with bias voltages of +5V for Vcc and – 5V for Vee. 2. When DC blocks are used, a 10K ohm return to GND is required on the RFC port.
Matched GaAs SPST Switch, DC - 3 GHz with TTL/CMOS Control Input SW05-0311 Specifications subject to change without notice. n North America: Tel. (800) 366-2266 n Asia/Pacific: Tel.+81-44-844-8296, Fax +81-44-844-8298 n Europe: Tel. +44 (1344) 869 595, Fax+44 (1344) 300 020 Visit www.macom.com for additional data sheets and product information. V 3.00 Pin Configuration Pin No. Function Pin No. Function
1 Vee 9 GND
2 GND 10 GND
3 GND 11 GND
4 GND 12 RF2
5 RF1 13 GND
6 GND 14 GND
7 GND 15 Vcc
8 GND 16 C1
Absolute Maximum Ratings 3 3. Operation of this device above any one of these parameters may cause permanent damage. 4. Standard CMOS TTL interface, latch-up will occur if logic signal is applied prior to power supply. Parameter Absolute Maximum Max Input Power
50 MHz
+27 dBm +34 dBm Supply Voltages Vcc Vee +5.5V -8.5V Control Voltage 4 -0.5V, to Vcc +0.5V Operating Temperature -40°C to +125°C Storage Temperature -65°C to +150°C Control Input Condition of Switch C1 RF1 to RF2 LO ON HI OFF Truth Table Pin Configuration (Top View) GND GND GND RF2 GND GND GND GND GND RF1 GND GND GND Orientation Mark Vee Vcc Electrical Specifications: TA = +25°C Parameter Test Conditions Frequency Units Min Typ Max Vee -5.0V to -8.0V — mA — — 1
Matched GaAs SPST Switch, DC - 3 GHz with TTL/CMOS Control Input SW05-0311 Specifications subject to change without notice. n North America: Tel. (800) 366-2266 n Asia/Pacific: Tel.+81-44-844-8296, Fax +81-44-844-8298 n Europe: Tel. +44 (1344) 869 595, Fax+44 (1344) 300 020 Visit www.macom.com for additional data sheets and product information. V 3.00 Typical Performance Curves Isolation vs. Frequency Insertion Loss vs. Frequency VSWR vs. Frequency
Ordering Information
Frequency (GHz) Isolation dB 0.5 1.5 Frequency (GHz) Loss (dB) +85°C +25°C -55°C 1.00 1.20 1.40 1.60 1.80 2.00 Frequency (GHz) VSWR VSWR On VSWR Off