R3896 HAMAMATSU

Document overview

  • PDF pages: 4

Technical content

Page 1

PHOTOMULTlPLlER TUBE

R3896

PATENT PENDING

High Q.E Multialkali Photocathode

New Electro–Optical Design

28mm (1-1/8 Inch) Diameter, 9-Stage, Side-On Type

FEATURES

High Sensitivity Luminous .......................................... 525 A/lm (Typ.) Radiant at 450nm (peak) ............................. 90mA/W (Typ.) at 633nm ......................................... 73mA/W (Typ.) Quantum Efficiency at 260nm (peak) .................................... 30% (Typ.) at 633nm (peak) .................................... 14% (Typ.) Wide Spectral Response ............................ 185 to 900nm High Signal to Noise Ratio Newly Designed Electro Optical Structure

APPLICATIONS

Biomedical Analysis Blood Analyzer, Flow Cytometer, DNA Sequencer Environmental Monitoring NOx Analyzer Spectroscopy Fluorescence Spectrometer, Raman Spectrometer, UV–VIS Spectrometer Semiconductor Industry Wafer Inspection, Particle Counter

Figure 1: Electro Optical Structure

LIGHT

PDF page 1 diagram

TPMSC0024EA

PDF page 1 diagram

Figure 2: Typical Spectral Response

TPMSB0049EB

PDF page 1 diagram

WAVELENGTH (nm)

Subject to local technical requirements and regulations, availability of products included in this promotional material may vary. Please consult with our sales office. lnformation furnished by HAMAMATSU is believed to be reliabIe. However, no responsibility is assumed for possibIe inaccuracies or ommissions. Specifications are subject to change without notice. No patent right are granted to any of the circuits described herein. © 1994 Hamamatsu Photonics K.K.

Page 2

PHOTOMULTlPLlER TUBE R3896

GENERAL

PDF page 2 diagram

MAXIMUM RATINGS (Absolute Maximum Values)

PDF page 2 diagram

CHARACTERISTlCS (at 25 )

PDF page 2 diagram

NOTES

A: Averaged over any interval of 30 seconds maximum. B: The light source is a tungsten filament lamp operated at a distribution temperature of 2856K. Supply voltage is 100 volts between the cathode and all other electrodes connected together as anode. C:The value is cathode output current when a blue filter(Coming CS-5-58 polished to 1/2 stock thickness) is interposed between the light source and the tube under the same condition as Note B. D:Red/White ratio is the quotient of the cathode current measured using a red filter(Toshiba R-68) interposed between the light source and the tube by the cathode current measured with the filter removed under the same conditions as Note B.

E: Measured with the same light source as Note B and with the voltage distribution ratio shown in Table 1 below.

Table 1:Voltage Distribution Ratio

Electrodes K Dy1 Dy2 Dy3 Dy4 Dy5 Dy6 Dy7 Dy8 Dy9 P
Ratio 1 1 1 1 1 1 1 1 1 1

SuppIy Voltage : 1000Vdc, K : Cathode, Dy : Dynode, P : Anode F: Measured with the same supply voltage and voltage distribution ratio as Note E after removal of light. G:The rise time is the time for the output pulse to rise from 10% to 90% of the peak amplitude when the entire photocathode is illuminated by a delta function light pulse. H:The electron transit time is the interval between the arrival of delta function light pulse at the entrance window of the tube and the time when the anode output reaches the peak amplitube. In measurement, the whole photocathode is illuminated. I: Also called transit time jitter. This is the fluctuation in electron transit time between individual pulses in

the signal photoelectron mode, and may be defined as the FWHM of the frequency distribution of electron transit times J: Hysteresis is temporary instability in anode current after light and voltage are applied.

lmax. lmin.

Hysteresis =

100(%) li

l max.

il l min. TIME

5 6 7 (minutes)

0

TPMSB0002EA

(1)Current Hysteresis The tube is operated at 750 volts with an anode current of 1 microampere for 5 minutes. The light is then removed from the tube for a minute. The tube is then re-illuminated by the previous light level for a minute to measure the variation. (2)Voltage Hysteresis The tube is operated at 300 volts with an anode current of 0.1 micro-ampere for 5 minutes. The light is then removed from the tube and the supply voltage is quickly increased to 800 volts. After a minute, the supply voltage is then reduced to the previous value and the tube is re-illuminated for a minute to measure the variation.

Page 3

Figure 3: Typical Temperature Characteristics of Dark Current (at 1000V, after 30minutes storage)

TPMSB0050EA

PDF page 3 diagram

TEMPERATURE (°C)

Figure 5: Typical Time Response

TPMSB0052EA

PDF page 3 diagram

SUPPLY VOLTAGE (V)

Figure 4: Anode Luminous Sensitivity and

Gain Characteristics

TPMSB0051EA

PDF page 3 diagram

SUPPLY VOLTAGE (V)

Figure 6: Typical Temperature Coefficient

of Anode Sensitivity

TPMSB0053EA

PDF page 3 diagram

WAVELENGTH (nm)

Page 4

PHOTOMULTlPLlER TUBE R3896

Figure 7: Dimensional Outline and Basing Diagram (Unit:mm)

PDF page 4 diagram
PDF page 4 diagram

DY6

PDF page 4 diagram

BOTTOM VIEW

(BASING DIAGRAM)

TPMSA0008EA

Cross Section

TPMSA0009EA

Figure 8: Optional Accessories (Unit:mm)

D Type Socket Assembly E717-21

Socket E678-11A

PDF page 4 diagram
PDF page 4 diagram

SOCKET

PDF page 4 diagram

SIGNAL OUTPUT RG-174/U

POWER SUPPLY GND

PDF page 4 diagram

R to R10 : 330k C1 to C3: 0.01 F

TACCA0002ED

TACCA0064EA

PDF page 4 diagram

Hamamatsu also provides C4900 series compact high voltage power supplies and C6270 series DP type socket assemblies which incorporate a DC to DC converter type high voltage power supply.

PATENT PENDING : JAPAN 4, USA 4, EUROPE 4

HAMAMATSU PHOTONICS K.K., Electoron Tube Center 314-5, Shimokanzo, Toyooka-village, Iwata-gun, Shizuoka-ken, 438-0193, Japan, Telephone: (81)539/62-5248, Fax: (81)539/62-2205 U.S.A.: Hamamatsu Corporation: 360 Foothill Road, Bridgewater. N.J. 08807-0910, U.S.A., Telephone: (1)908-231-0960, Fax: (1)908-231-1218 Germany: Hamamatsu Photonics Deutschland GmbH: Arzbergerstr. 10, D-82211 Herrsching am Ammersee, Germany, Telephone: (49)8152-375-0, Fax: (49)8152-2658 France: Hamamatsu Photonics France S.A.R.L.: 8, Rue du Saule Trapu, Parc du Moulin de Massy, 91882 Massy Cedex, France, Telephone: (33)1 69 53 71 00, Fax: (33)1 69 53 71 10 United Kingdom: Hamamatsu Photonics UK Limted: Lough Point, 2 Gladbeck Way, Windmill Hill, Enfield, Middlesex EN2 7JA, United Kingdom, Telephone: (44)181-367-3560, Fax: (44)181-367-6384

TPMS1013E03

North Europe: Hamamatsu Photonics Norden AB: Färögatan 7, S-164-40 Kista Sweden, Telephone: (46)8-703-29-50, Fax: (46)8-750-58-95

OCT. 1994

Italy: Hamamatsu Photonics Italia: S.R.L.: Via Della Moia, 1/E, 20020 Arese, (Milano), Italy, Telephone: (39)2-935 81 733, Fax: (39)2-935 81 741