DATASHEET SEARCH SITE
Document overview
- Manufacturer or author: Provided By digicamel.com
- PDF pages: 12
Technical content
OLED Interface Board. Part Number: MCIB‐13 Version: 1 Date: 26/10/2015
Revision History
Date Description of change 26/6/2015 First draft Midas Components Limited Electra House
32 Southtown Road
Telephone +44 (0)1493 602602 Fax +44 (0)1493 665111 Email sales@midasdisplays.com Website www.midasdisplays.com
evaluation of TAB OLED character displays. Figure 1. MCIB‐13 Interface Board
Features
33 way 0.7mm pitch TAB OLED connector. 20 way 1.0mm pitch SHD connector. Mechanical dimensions 70 x 35 x 6 mm. Can be use with MCIB‐12 and UNO32. Switch selectable: Enable/disable internal regulator. Select scanning direction for COM signal. Select the mapping between the display data colu mn address and the segment driver. Set the appropriate character ROM. Set the character ROM/RAM management. Select the communication protocol. Pin compatible with the following Midas displays: MCOT42005AX MCOT22005AX MCOT21605AX Midas Components Limited Electra House Telephone +44 (0)1493 602602 Fax +44 (0)1493 665111 Email sales@midasdisplays.com Website www.midasdisplays.com
2 VSL Segment voltage reference
3 VSS Ground
4 REGVDD Internal Regulator
5 SHLC COM Signal
6 SHLS SEG Signal
9 BS0 MCU Interface Selection
10 BS1 MCU Interface Selection
11 BS2 MCU Interface Selection
12 GPIO General Purpose I/O
14 RES# Power Reset
15 D/C# Data/Command Control
16 R/W#(WR#) R/W Selector or Write
17 E(RD#) R/W Enable or Read
18 D0 Data 0
19 D1 Data 1
20 D2 Data 2
21 D3 Data 3
22 D4 Data 4
23 D5 Data 5
24 D6 Data 6
25 D7 Data 7
26 IREF Current Reference
27 ROM0 ROM Selection
28 ROM1 ROM Selection
29 OPR0 ROM/RAM Management
30 OPR1 ROM/RAM Management
31 VCOMH Voltage Output
32 VCC +12V
Table 2. MC1 Connector
Table 3. SHD Connector
1 VCC +12V
3 GND 0V
5 GND 0V
7 E(RD#) R/W Enable or Read
8 R/W#(WR#) R/W Selector or Write
9 D/C# Data/Command Control
10 D0 Data 0
11 D1 Data 1
12 D2 Data 2
13 D3 Data 3
14 D4 Data 4
15 D5 Data 5
16 D6 Data 6
17 D7 Data 7
18 RES# Power Reset
19 DISP Display On
20 GPIO General Purpose I/O
0 Regulator disabled
1 Regulator Enabled
Table 4. Internal Regulator Table 5. COM Signal
0 Normal Mapping Direction
1 Reverse Mapping Direction
Table 6. SEG Signal
1 REGVDD Internal Regulator (Table 4)
2 SHLC COM Signal (Table 5)
3 SHLS SEG Signal (Table 6)
4 BS0 MCU Interface Selection (Table 7)
5 BS1 MCU Interface Selection (Table 7)
6 BS2 MCU Interface Selection (Table 7)
7 ROM0 ROM Selection (Table 8)
8 ROM1 ROM Selection (Table 8)
9 OPR0 ROM/RAM Management (Table 9)
10 OPR1 ROM/RAM Management (Table 9)
0 Normal Scanning Direction
1 Reverse Scanning Direction
Table 7. MCU Interface Selection Table 8. ROM Selection Table 9. ROM/RAM Management
Table 10. Interface Table 11. Power Supply
Table 12. Absolute Maximum ratings Table 12. Typical Electrical Characteristics
Figure 2. MCIB‐13 with UNO32 and MCIB‐12 8‐Bit Parallel Mode Figure 3. Close up of MCIB‐13 Board’s Links and Switch Positions.
Figure 4. MCIB‐13 with UNO32 and MCIB‐12 I2C Interface Figure 5. Close up of MCIB‐13 Board’s Links and Switch Positions.
*Note all measurements are in mm unless stated otherwise. Midas Components Limited Electra House Telephone +44 (0)1493 602602 Fax +44 (0)1493 665111 Email sales@midasdisplays.com Website www.midasdisplays.com