HD-02103AST HIROSE
Document overview
- Manufacturer or author: Provided By digicamel.com
- PDF pages: 3
Technical content
1.Insulation resistance 2.Vibration 3.Shock 4.Temperature cycle 5.High temperature exposure 6.Low temperature exposure 7.Corrosion resistance 8.Sulfur dioxide gas Stick Coupler HD-02103AST Series I Features 1.High Performance Low insertion loss: 0.1 dB max. (Typical) 2.High Power Handling 200 W max. power handling capability. Efficient heat dissipation characteristic. 3.Extremely Small Size and Lightweight Innovative Hirose Electric design of the case and cover is behind the extremely small size and lightweight. 4.Simple installation Standard screw mounting and solder tabs allows direct mounting to planar circuits.I Specifications Note: The frequency range and the maximum input power will differ depending on the products. G The test methods conform to MIL-STD-202. I Material Ratings Frequency range Characteristic impedance Maximum Input Power 1800 ~ 2200 MHz 50 ohms 200 W Operating temperate range Operating relative humidity 0ç to +80ç 95% Max. Characteristic Requirement Conditions Component Material Finish Case Brass Nickel Plated Board Dielectric Gold plated Tabs Phosphor bronze Gold plated 1000M ohms Min. DC 250V Frequency of 10 to 2000 Hz, overall amplitude of 1.52 mm, acceleration of 98 m/s 2 for 2 hours in each of 3 directions Acceleration of 490 m/s2, sine half-wave waveform, 3 cycles in each of the 3 axis Temperature: -55ç¡ +5çto +35ç¡ +85ç¡ +5çto +35ç Time: 30¡ 5 max.¡ 30¡ 5 max. (Minutes)100 cycles 96 hours at 85ç 96 hours at -55ç Exposed to 20% salt water solution for 48 hours 96 hours in 10 ppm concentration No electrical discontinuity of 1 µs or more No damage, cracks, or parts dislocation No damage, cracks, or parts dislocation No serious corrosion No damage, cracks, or parts dislocation
(GHz) Coupling (dB) Frequency Sensitivity (dB) IsoIation (dB Min) V.S.W.R. (Max) Weight (g) Power (W) Fig. 24±0.4 2-Ø2.7±0.3 Through hole 31.2±0.35 (37.3) 4-(1.2) (6.65) (3.05) 6.65±0.4 3.05±0.35 4.8±0.35 (8.8) I PCB Mounting Pattern 31.2±0.1 2-M2.3∞0.4 I Mounting Sequence Phillips head driver-Max torque of 14.7N Step 1. Step 2. Tab soldering M2.3x0.4 (Not supplied) Mounting surface groove Soldering areas (2.3) (2.57)
2.5 3.5 2.22.01.8 Frequency(GHz) Output / Coupling(dB) Isolation(dB) Output Coupling Isolation Primary Line Secondary Line 1.2 1.15 1.1 1.05 1.0 2.22.01.8 VSWR Cover Fixture Fixture pattern Temperature inside test tank 120 100 1.2 17750 100 1500 Temperature(ç) Vector Network Analyzer (f=2.155GHz) High Power AMP (f=2.155Hz) HD-02103AST Termination Termination Power meter Test jig Termination Test fixture Thermal resistance value [Thermal resistance value : 9.0ç/W] Frequency : 2.155GHz Test Circuit I 200 W Power Test