DE475-102N20A IXYS
Document overview
- PDF pages: 5
Technical content
Page 1


Symbol Test Conditions
Maximum Ratings
TJ = 25°C to 150°C
VDSS
1000 V

TJ = 25°C to 150°C; RGS = 1 MΩ
VDGR
1000 V
Continuous
VGS
±20 V
Transient
VGSM
±30 V
Tc = 25°C
ID25
20 A
Tc = 25°C, pulse width limited by TJM
IDM
120 A
Tc = 25°C
IAR
20 A
Tc = 25°C
EAR
30 mJ
IS ≤ IDM, di/dt ≤ 100A/µs, VDD ≤ VDSS,
5 V/ns
Tj ≤ 150°C, RG = 0.2Ω
dv/dt
IS = 0
200 V/ns
DRAIN
PDC
1800 W

Tc = 25°C
PDHS
730 W
Derate 4.4W/°C above 25°C
Tc = 25°C
PDAMB
4.5 W
RthJC
0.08 C/W
RthJHS
0.20 C/W

Characteristic Values
Symbol Test Conditions
TJ = 25°C unless otherwise specified
| min. | typ. | max. |
|---|---|---|
| V V = 0 V, I = 3 ma 1000 DSS GS D | V | |
| V V = V , I = 250 µa 3.0 GS(th) DS GS D | 3.6 | 5.0 V |
| I V = ±20 V , V = 0 GSS GS DC DS | ±100 nA | |
| I V = 0.8 V T = 25°C DSS DS DSS J V = 0 T = 125°C GS J | 50 µA 1 mA | |
| R V = 15 V, I = 0.5I DS(on) GS D D25 Pulse test, t ≤ 300µS, duty cycle d ≤ 2% | 0.6 Ω | |
| g V = 15 V, I = 0.5I , pulse test 6 fs DS D D25 | 9 | S |
| T -55 J | +150 °C | |
| T JM | 150 | °C |
| T -55 stg | +150 °C | |
| T 1.6mm (0.063 in) from case for 10 s L | 300 | °C |
| Weight | 3 | g |
°C
°C
°C
Page 2
Symbol
Test Conditions
Characteristic Values

Source-Drain Diode
Characteristic Values (TJ = 25°C unless otherwise specified)

CAUTION: Operation at or above the Maximum Ratings values may impact device reliability or cause permanent damage to the device.
Information in this document is believed to be accurate and reliable. IXYSRF reserves the right to make changes to information published in this document at any time and without notice.
For detailed device mounting and installation instructions, see the “Device Installation & Mounting Instructions” technical note on the IXYSRF web site at;
http://www.ixysrf.com/pdf/switch_mode/appnotes/7de_series_mosfet_installation_instructions.pdf
IXYS RF reserves the right to change limits, test conditions and dimensions. IXYS RF MOSFETS are covered by one or more of the following U.S. patents:
4,835,592
4,860,072
4,881,106
4,891,686
4,931,844
5,017,508
5,034,796
5,049,961
5,063,307
5,187,117
5,237,481
5,486,715
5,381,025
5,640,045
Page 3

Fig. 1
4 5 6 7 8 9 10 11 12
VGS, Gate-to Source Voltage (V)
Fig. 3 Gate Charge vs. Gate-to-Source Voltage VGS = 500V, ID = 10A, Ig = 4mA

0 50 100 150 200 250
Gate Charge (nC)
Fig. 5
VD S vs. Capacitance
VDS, Drain-to-Source Voltage (V)
Fig. 4
Extended Typical Output Characteristics

0 25 50 75 100 125
VDS, Drain-to-Source Voltage (V)

10000
VDS Voltage (V)
Page 4
Fig. 6 Package Drawing

Page 5
102N20A DE-SERIES SPICE Model The DE-SERIES SPICE Model is illustrated in Figure 7. The model is an expansion of the SPICE level 3 MOSFET model. It includes the stray inductive terms LG, LS and LD. Rd is the RDS(ON) of the device, Rds is the resistive leakage term. The output capacitance, COSS, and reverse transfer ca- pacitance, CRSS are modeled with reversed biased diodes. This provides a varactor type response necessary for a high power device model. The turn on delay and the turn off delay are adjusted via Ron and Roff.

Figure 7 DE-SERIES SPICE Model
This SPICE model may be downloaded as a text file from the IXYSRF web site at http://www.ixysrf.com/products/switch_mode.html http://www.ixysrf.com/spice/de475-102n20a.html Net List: .SUBCKT 102N20A 10 20 30 \* TERMINALS: D G S \* 1000 Volt 20 Amp 0.6 ohm N-Channel Power MOSFET \* REV.A 10-29-01 M1 1 2 3 3 DMOS L=1U W=1U RON 5 6 0.5 DON 6 2 D1 ROF 5 7 .1 DOF 2 7 D1 D1CRS 2 8 D2 D2CRS 1 8 D2 CGS 2 3 6.2N RD 4 1 0.5 DCOS 3 1 D3 RDS 1 3 5.0MEG LS 3 30 .5N LD 10 4 1N LG 20 5 1N .MODEL DMOS NMOS (LEVEL=3 VTO=3.0 KP=3.8) .MODEL D1 D (IS=.5F CJO=1P BV=100 M=.5 VJ=.6 TT=1N) .MODEL D2 D (IS=.5F CJO=400P BV=1000 M=.4 VJ=.6 TT=400N RS=10M) .MODEL D3 D (IS=.5F CJO=900P BV=1000 M=.3 VJ=.4 TT=400N RS=10M)
.ENDS
Doc #9200-0238 Rev 6 © 2009 IXYS RF
An IXYS Company 2401 Research Blvd., Suite 108 Fort Collins, CO USA 80526 970-493-1901 Fax: 970-493-1903 Email: sales@ixyscolorado.com Web: http://www.ixyscolorado.com