BAI-015 ITT

Document overview

  • Manufacturer or author: Provided By digicamel.com
  • PDF pages: 1

Technical content

BAI-015 SMB Right Angle Connectors, Crimp Type for Braided Cable fo) a c= 3 EXTENSION o CRIMP FERRULE CAP BoDyY x< fa) oe iS) 1. Trim cable to dimensions shown taking care not to nick braid or center Ss conductor. Tin center conductor (DO NOT OVER TIN) then slip crimp ferrule > STEP 1 D over cable. a A ot [- 8 . O° Assembly Instruction No. A B Cc u Ste § 2. Insert trimmed cable into back end of body. The tubular body extension will STEP 2 slide under the braid with the rear portion of extension fitting under the 4.50 (058) SLIT @2 jacket as shown. The center conductor will extend into slot in contact. 100° APART OPTIONAL) NOTE: On smaller diameter cables, two longitudinal slits in the jacket, 180° >| f — apart, may be cut to ease assembly. We ts , ‘ i F PAX 777 3. Slip ferrule up over braid to face of square body and crimp, using Cannon’s S| RR wet Crimp Tool and suitable Die Set (see table). STEP 3 Cable Numbers Cable Code Die Size Die Set RG142/U 9052 5,41 (.213) K29265 RG196/U 3196 2,67 (.105) K29263 RG316/U 0000 3,25 (.128) K29263 RG316/U 3188 3,25 (.128) K29263 RD316 9399 3,84 (.151) 1025/9 4. Using a small soldering iron solder center conductor to contact. NOTE: The center conductor should not protrude beyond the contact to touch the body. Solder should not protrude beyond the slotted section of the contact. 5. Locate the cap in rear of body and dimple or lightly punch to ensure it is locked in position. (A flat punch is recommended). SUPPORT BODY ON SHOULDER DURING THIS OPERATION. : Only common cable retention features are shown in detail. Various body configurations can apply. Cannon Dimensions ave ‘shown: mm (inch) . peciicatons and dimensions subject to change : ~ & ITT Industries www..ittcannon.com 49 Engineered for life