AM2520SURC08 KINGBRIGHT

Document overview

  • Manufacturer or author: Provided By digicamel.com
  • PDF pages: 4

Technical content

Features

SUBMINIATURE PACKAGE. WIDE VIEWING ANGLE. YOKE LEAD. LONG LIFE - SOLID STATE RELIABILITY. LOW PACKAGE PROFILE. PACKAGE : 1000PCS / REEL. RoHS COMPLIANT. SUBMINIATURE SOLID STATE LAMP Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. Specifications are subject to change without notice.

SPEC NO: DSAD1266 REV NO: V.2 DATE: MAR/05/2005 PAGE: 2 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: W.J.ZHU ERP:1202000698 Selection Guid e Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at T A =25 °C Absolute Maximum Ratings at T A =25 °C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. Part No. Dice Lens Type Iv (mcd) @ 20mA Viewing Angle Min. Typ. 2θθθθ1/2 AM2520SURC08 HYPER RED (InGaAlP) WATER CLEAR 280 1000 20 ° Symbol Parameter Device Typ. Max. Test Conditions Units λpeak Peak Wavelength Hyper Red 640 nm IF=20mA λD Dominant Wavelength Hyper Red 628 nm IF=20mA ∆λ 1/2 Spectral Line Half -width Hyper Red 27 nm IF=20mA C Capacitance Hyper Red 45 pF VF=0V;f=1MHz VF Forward Voltage Hyper Red 1.9 2.5 V IF=20mA IR Reverse Current Hyper Red 10 uA VR = 5V Parameter Hyper Red Units Power dissipation 170 mW DC Forward Current 30 mA Peak Forward Current [1] 185 mA Reverse Voltage 5 V Operating/Storage Temperature -40°C To +85°C

SPEC NO: DSAD1266 REV NO: V.2 DATE: MAR/05/2005 PAGE: 3 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: W.J.ZHU ERP:1202000698 Hyper Red AM2520SURC08

SPEC NO: DSAD1266 REV NO: V.2 DATE: MAR/05/2005 PAGE: 4 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: W.J.ZHU ERP:1202000698 AM2520SURC08 Recommended Soldering Pattern (Units : mm ) Remarks: If there is sorting requirement (eg. forward voltage, luminous intensity or wavelength),the condition as follows: 1.Wavelength: +/ -1nm (Test condition is based on the sorting standard). 2.Luminous intensity: +/ -15% (Test condition is based on the sorting standard). 3.Forward voltage: +/ -0.1V (Test condition is based on the sorting standard). Tape Specifications (Units : mm )