96DW-R5 YUANDEAN

Document overview

  • Manufacturer or author: Provided By www.digicamel.com(FREE DATASHEET DOWNLOAD SITE)
  • PDF pages: 4

Technical content

FEAT URE S： 4:1 Wide Input Range 100% Burned In High Efficiency Up To 88% Customized Solutions Available Remote Control:On/Off Operating Temperature From -40℃ TO +85℃

3 Years Warranty

30Watt 1.6KV Isolated 4：1 Input Voltage Range Single & Dual Output 2” x 1” Specifications typical at TA=25°C, nominal input voltage and rated output current unless otherwise specified Part Number Input Voltage Input Current Output Voltage Output Current Output Ripple Noise Efficiency Capacitor Load Vdc No Load (mA TYP) Full Load (mA TYP) Vdc Full Load (mA) mVp-p %TYP uF MAX 96DW-24S03R5NL 9-36 120 1265 3.3 7500 100 86 20000 96DW-24S05R5NL 9-36 130 1488 5.0 6000 100 87 14400 96DW-24S12R5NL 9-36 50 1471 12 2500 100 88 3000 96DW-24S15R5NL 9-36 50 1471 15 2000 100 88 2000 96DW-24D12R5NL 9-36 60 1471 ±12 1250 100 88 ±2000 96DW-24D15R5NL 9-36 60 1471 ±15 1000 100 88 ±1300 96DW-48S03R5NL 18-75 70 629 3.3 7500 100 86 20000 96DW-48S05R5NL 18-75 80 744 5.0 6000 100 87 14400 96DW-48S12R5NL 18-75 30 727 12 2500 100 88 3000 96DW-48S15R5NL 18-75 30 727 15 2000 100 88 2000 96DW-48D12R5NL 18-75 30 727 ±12 1250 100 88 ±2000 96DW-48D15R5NL 18-75 30 727 ±15 1000 100 88 ±1300 YUAN DEAN SCIENTIFIC YUAN DEAN SCIENTIFIC CO.,LTD Rev:0 2018/10/31

96 DW-R5 SERIES

Applications

Note: 1. BELLCORE TR-NWT-000332. Case I: 50% Stress, Temperature at 40ºC. (Ground fixed and controlled environment) MIL-STD-217F Notice2 @Ta=25 ºC, Full load (Ground, Benign, controlled environment) 2. The ON/OFF control pin voltage is referred to -Input. (Leave open if not used.)

96 DW-R5 SERIES YUAN DEAN SCIENTIFIC CO.,LTD Rev:o 2018/10/31 Part Number Input Specifications Parameters Conditions Min Typ Max Units Voltage Types 4:1 Filter Pi Type Input surge voltage 100mS max 24V input 50 Vdc 48V input 100 Vdc Input reflected ripple current Nominal Vin and full load 20 mAp-p Start up time Nominal Vin and constant resistive load Power up 30 mS Remote ON/OFF 30 mS Start-up voltage 24V input 9 Vdc 48V input 18 Vdc Shutdown voltage 24V input 8 Vdc 48V input 16 Vdc Protection Fuse Recommended Remote ON/OFF (Note 2) DC-DC ON OPEN DC-DC OFF Short to ground Input current of Remote control pin Nominal Vin -0.5mA ~ +0.5mA Remote off state input current Nominal Vin 3mA Vp (1)+Vin (2)-Vin (3)Ctrl (4)+Vout (5)-Vout (6)Trim RL SW a b Vin+ When pin3 short to pin2,D/D ON=>OFF When pin3 leave open,D/D=>ON control Voltage Ra= Vp-0.6 0.5mA Ω 0.5mA Ra to pin3 NPN to pin2(-Vi) (on/off control) Output Specifications Parameters Conditions Min Typ Max Units Voltage Tolerance Full load@Vin(nom.) ±2 % Short Circuit /Restart Protection Hiccup, automatic recovery Over Load Protection nominal input 150 V Over Voltage Protection (Zener Diode Clamp) 3.3V Output 3.9 V 5.0V Output 6.2 V 12V Output 15 & ±15 V 15V Output 18 & ±18 V Line Regulation LL to HL at Full Load ±0.5 % Load Regulation Single ±0.5 % Load Regulation Dual, Balance Load,25% to 100% load ±1.0 % Cross Regulation Dual (25% to 100% load) ±5.0 % Ripple & Noise 20MHz bandwidth 100 mVp-p Transient response recovery time 25% load step change 250 350 us External Trim Adj. Range ±10% of Output The components used in the above figure, together with the manufacturers’ part numbers for these components, are as follows: Derating Curve (without Heat-Sink) -48S C2/C3 1000pF/2KV 1808 MLCC 2.2µF/100V 1812 MLCC -24S Single Output 4.7µF/50V 1812 MLCC 1000pF/2KV 1808 MLCC -48D C2/C4 1000pF/2KV 1808 MLCC 2.2µF/100V 1812 MLCC -24D Dual Output 4.7µF/50V 1812 MLCC 1000pF/2KV 1808 MLCC

Parameters Conditions Min Typ Max Units Isolation Resistance 500Vdc 1000 MΩ Switching Frequency

300 KHz

Case material Nickel coated copper with no-conductive base Epoxy (UL94-V0) Epoxy (UL94-V0) Isolation Voltage For 10 seconds 1600 VDC Design meets safety IEC60950-1, UL60950-1, EN60950-1 Dimensions -R5NL 50.8X 25.4 X 10.6 mm -R5HSNL 50.8X 25.4 X 15.3 mm Weight 36.5 g MTBF (Note 1) BELLCORE-TR-NWT-000332 3.163 x 10 6 hrs MIL-HDBK-217F 4.347 x 10 5 hrs 96 DW-R5 SERIES YUAN DEAN SCIENTIFIC CO.,LTD Rev:o 2018/10/31 Environmental Specifications Parameters Conditions Min Typ Max Units Operating Temperature -40 85 ℃ Maximum case temperature 105 ℃ Storage Temperature -55 125 ℃ Thermal impedance @20LFM Convection 12 ºC/Watt Convection with heat-sink 10 ºC/Watt Thermal shock MIL-STD-810F Vibration MIL-STD-810F Relative humidity 5% to 95% RH EMC Characteristics Parameters Conditions Min Typ Max Units EMI EN55022 Class A ESD EN61000-4-2 Air ±8KV Perf. Criteria A Contact ±6KV Perf. Criteria A Radiated immunity EN61000-4-3 10 V/m Perf. Criteria A Fast transient EN61000-4-4 ± 2KV Perf. Criteria A Surge EN61000-4-5 ± 1KV Perf. Criteria A Conducted immunity EN61000-4-6 10 Vrms Perf. Criteria A Recommended Filter for EN55022 Class A Compliance External Output Trimming Output can be externally trimmed by using the method shown below. Recommended EN55022 Class A Filter Circuit Layout

Single +Vin -Vin Remote ON/OFF +Vout -Vout Trim Dual +Vin -Vin Remote ON/OFF +Vout COM -Vout 96 DW-R5 SERIES YUAN DEAN SCIENTIFIC CO.,LTD Rev:0 2018/10/31 -R5NL -R5HSNL