DATASHEET SEARCH SITE

Document overview

  • PDF pages: 2

Technical content

Page 1

PDF page 1 diagram

Mighty Mouse Connectors with Size #8 Quadrax, Twinax,

Coax or Power Contacts

Size #8 50 Ohm Coax Contacts 852-042 and 852-043

Size #8 50 ohm contacts for low loss high performance coax cable

PDF page 1 diagram

K

Coax contacts fit Glenair Series 80 Mighty Mouse connectors and MIL-DTL-38999

Series I, III and IV connectors with size 8 contact cavities. 50 ohm nominal

impedance. 0-2.5 GHz frequency range. Solder conductor to center contact is

solder type, shield termination is crimp type. Supplied as unassembled kit with

contact body, center contact, outer ferrule and sealing boot. Contacts are snap-in,

rear release with plastic extraction tool. Gold-plated copper alloy, Teflon® insulator.

See following page for information on coaxial cable.

Fig. Contact Type Part Number Contact Only Part Number Contact and Sealing Boot Sealing Boot
Fig. 1 Pin 852-043 852-043F 859-042-02
Fig. 2 Socket 852-042 852-042F 859-042-02
PDF page 1 diagram
PDF page 1 diagram

.029 (0.74)

HEX CRIMP

852-043

852-042

HEX CRIMP

Specifications
DESCRIPTION REQUIREMENT
Nominal Impedance 50 Ohms
Frequency Range 0 – 2.5 GHz
Dielectric Withstanding Voltage 1300 Vac sea level, 250 Vac at 50,000 feet
Insulation Resistance 5000 megohms minimum
Durability 500 mating cycles
Materials, Finishes
Contact body, center contact, ferrule Copper Alloy
Contact finish 50 microinches gold over nickel plating
Dielectric Fluorocarbon

Contact Removal Tool

Sealing Boot

Wire Dia Wire Dia. . (in.) (mm.) Part Number
.090 - .130 2.3 - 3.3 859-042-01
.130 - . 170 3.3 - 4.3 859-042-02
.170 - . 205 4.3 - 5.2 859-042-03

Plastic tool extracts wired contact from Optional sealing boot is recommended.

connector. First, remove sealing boot, Slide boot onto wire before terminating

then insert tool from rear of connector. contact. After contact is installed in

connector, slide boot forward into

Size Part Number Military Part Number
#8 859-049 M81969/14-12

connector grommet to seal the contact

cavity. "F" suffix on contact part number

specifies contact supplied with 859-

PDF page 1 diagram
PDF page 1 diagram
PDF page 1 diagram

© 2014 Glenair, Inc.

Series 80 Mighty Mouse

U.S. CAGE Code 06324

Rev. 07.07.15

Printed in U.S.A.

GLENAIR, INC. • 1211 AIR WAY • GLENDALE, CA 91201-2497 • 818-247-6000 • FAX 818-500-9912

K-26

www.glenair.com

E-Mail: sales@glenair.com

Page 2

PDF page 2 diagram

Mighty Mouse Connectors with Size #8 Quadrax, Twinax,

Coax or Power Contacts

Size #8 50 Ohm Coax Contacts 852-042 and 852-043

Termination tools for size #8 50 ohm coax contacts

K

Terminate inner contact to center conductor of cable with soldering iron. The

PDF page 2 diagram

outer ferrule is terminated to the cable shield with a M22520/5-01 parallel action

crimper and a hex die.

A

B

Parallel action tool terminates cable shield to

Hex die set for terminating cable shield to

contact ferrule. 11 inches OAL, 2.0 pounds.

contact ferrule. Hardened steel, black oxide

Anodized aluminum frame, steel mechanism,

finish.

plastic handles. Accepts all M22520/5 die sets.

Figure Part Number Military Part Number Daniels Part Number
A 809-129 M22520/5-01 HX4
B 859-051 M22520/5-05 Y197

Cable information (reference only, not sold by Glenair)

Coax contacts 852-042 and 852-043 are designed for use with LLSB-200 cable. This low loss, flexible cable is suitable for shipboard, airframe and tactical vehicles. Manufactured by Times Microwave, this cable is qualified to MIL-DTL-17/220. Jacket

is non-halogen, low smoke black UV resistant cross-linked polyethylene.

Times Microwave Part No. LLSB-200
Military Part Number M17/220-0001
Impedance 50 ± 2
Shielding Efefctiveness (dB) 90 min.
Conductor Diameter .044 (1.12)
Conductor Type Bare Copper
Dielectric Diameter .118 (3.0)
Outer Shield Diameter .144 (3.66)
Jacket Diameter .195 (4.95)
Weight (lbs/100 ft.) 37.4
Capacitance (pF/ft) 27.0
Velocity of Propagation % 80
Temperature Range -30° to +85°C
Attenuation (dB/100 ft)
10 MHz 1.3
100 MHz 3.8
400 MHz 7.7
1 GHz 12.0
2.5 GHz 20.0
PDF page 2 diagram

OUTER BRAID SHIELD

DIELECTRIC CORE

Dimensions in Inches (millimeters) are subject to change without notice.

© 2014 Glenair, Inc.

Series 80 Mighty Mouse

U.S. CAGE Code 06324

Rev. 07.07.15

Printed in U.S.A.

GLENAIR, INC. • 1211 AIR WAY • GLENDALE, CA 91201-2497 • 818-247-6000 • FAX 818-500-9912

K-27

www.glenair.com

E-Mail: sales@glenair.com