DATASHEET SEARCH SITE

Document overview

  • Manufacturer or author: Provided By digicamel.com
  • PDF pages: 3

Technical content

Connector- Specific Kit 679167- 1 for 408- -9872 LOC B 1 of 3E2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company All Rights Reserved TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. *Trademark. Other logos, product and/or Company names may be trademarks of their respective owners. TOOLING ASSISTANCE CENTER 1-- 800-- 722-- 1111 PRODUCT INFORMATION 1- -800- -522- -6752 This controlled document is subject to change. For latest revision and Regional Customer Service, visit our website atwww.te.com

18 Mar 11 Rev EAMP- LATCH* System 50 Receptacle Connectors

Lower Insert Locators Upper Tool Cable Stop Typical Application Manual Arbor Frame Assembly 91085- -2 (Ref) Base Assembly Universal Arbor Tool 768338- -2 Guard (Ref) 1. INTRODUCTION This instruction sheet covers the installation and setup procedures for Connector- -Specific Kit 679167- -1. The connector- -specific kit is used with Base Assembly Universal Arbor Tool 768338- -2 (408- -9875) and Manual Arbor Frame Assembly 91085- -2 (408- -7777) (shown in Figure 1) or Pneumatic Auto- -Cycle Unit 91112- -3 (408- -6732) to terminate AMP- -LATCH System 50 receptacle connectors onto cable. Refer to instruction sheets (given in parenthesis) supplied with the tool for tooling information. For information on AMP- -LATCH connectors, contact PRODUCT INFORMATION at the number at the bottom of this page. Reasons for reissue of this instruction sheet are provided in Section 6, REVISION SUMMARY. Dimensions in this instruction sheet are in millimeters [followed by inches in brackets]. 2. DESCRIPTION(Figure 1) The connector- -specific kit consists of an upper tool, a lower insert, two locators, and a cable stop. The upper tool is secured to the upper tool mount and applies an even force over the length of the connector during termination. The locators and the lower insert properly align the connector for termination. 3. CABLE REQUIREMENT The receptacle connectors accept 0.64 [.025] centerline ribbon cable with solid or stranded conductors size 30 AWG or stranded conductors size 32 AWG (7 strands/40 AWG). Refer to Figure 2 for recommended cable dimensions. ORIGINAL INSTRUCTIONS NOTE i