3000-U11-02 AMKA

Document overview

  • Manufacturer or author: Provided By www.digicamel.com(free datasheet download site)
  • PDF pages: 1

Technical content

Electronic Locking & Monitoring 3 0 0 0 -U 1 1 -02 © EMKA Electronic, all rights reserved Rev . 20 11-07-12 / Roh -Art. -Nr. 1571 Page 1 of 1 Griffmodul für 8 Griffe – Bauform Box Das Modul 3000wU11w02 ist Bestandteil des ELM Systems. Es bietet 8 unabhängige Ports zur Steuerung von aufspringenden Griffen. Alternativ kann an jeden Port ein potenzia lfreier Türkontakt zur Überwachung des Türzustandes (AUF/ZU) angeschlossen werden. Technische Änderungen vorbehalten. Handle module for 8 handles – box style The 3000wU11w02 module is part of the ELM system. It has 8 independent ports to control and monitor sp ring loaded swing handles. Door contacts can be connected to each port to monitor the door status (OPEN/CLOSED) in addition to the standard handle locked/unlocked status monitoring. Subject to technical changes Power supply: 12 VDC, 50 mA ; shortly 300 mA afte r opening cycle Handle output: min. 2.8 Ω. A 40 V, max. 15 A, pu lse of max. 30 ms duration opens the handle. 8 sec. recovery time required between two opening cycles LED CAN: flashing when active, otherwise ON LED STC: normally OFF, flashing when module status is changed Fig. 1: 3000-U11-02 front Box dimensions: 135 x 32 x 229 mm (W x H X D) CAN bus wiring The box modules are linked together by RJ45 patch c ables. Connect CANwOut of a module to CANwIn of the next module. Open CANwIn / CANwOut sockets must be equipped with a terminating plug for proper operation! Terminating plugs are supplied with the communication module 3000wU14w02. Power supply A 12 VDC, 500 mA (e.g. 3003w03w02) power supply is required for each handle module. From this, power can be fed to other modules – keypads, communication or sensor modules, prox card readers etc. by CAT 5, CANbus patch cabl es. Check that the total current requirements do not exceed the rating of the power supply. Addressing Module addressing is done via standard software (ELMcontrol). Please refer to software manual for details. Fig. 2: 3000-U11-02 rear Fig. 3:300-U11-02 top side label