3000-U08-01 AMKA
Document overview
- Manufacturer or author: Provided By www.digicamel.com(free datasheet download site)
- PDF pages: 1
Technical content
Electronic Locking & Monitoring 3 0 0 0 - U 0 8 - X X EMKA Beschlagteile GmbH & Co. KG Rev. 2023-08-14 / Roh Art.-Nr. 2043 Page 1 of 1 Bedienmodul Tastatur Die Tastatur 3000-U08-xx ist Bestandteil des ELM-Sy stems und dient zum Öffnen von Verschlüssen per PIN -Code. In Kombination mit einem Kartenleser wird über die Tas tatur die Türnummer ausgewählt, während die Karte d as Medium zur Authentifizierung darstellt. Eine weitere Betriebsart ist die 2-Faktor-Authentifzierung mit Türnummer, PIN-Code und Karte. 3000-U08-00 beinhaltet ein 3 m Kabel für den Anschluss an ELM-Module der Bauform Kit über den CAN-Bus 3000-U08-01 beinhaltet ein 3 m Kabel für den Anschluss an ELM-Units über den CAN-Bus Technische Änderungen vorbehalten. Keypad Module The keypad 3000-U08-xx part of the ELM system used open locks via PIN code. In combination with a card reader the lock number is entered via keypad and the card used for authentication. An additional operating mode is the 2-factor-authentication with lock number and, PIN code and card. 3000-U08-00 includes a 3 m cable for connection to ELM Kit modules via CAN-bus 3000-U08-01 includes a 3 m cable for connection to ELM units via CAN-bus Subject to technical changes Dimensions: 113 x 64 x 12 mm³ Board: H1m8v1e1 Power supply: 12 VDC, 50 mA. The power supply is fed via CAN-bus connecting cable. Right LED: Shows green if keypad is assigned and polled correctly, else red.) Left LED: In idle state off. Shows yellow if entries are made and flashes green or shows red if entries are confirmed with 'E', depending on result. Fig. 1: 3000-U08 rear (partial) Fig. 2: 3000-U0 8 drilling plan Addressing The module address can be assigned via dip switch (static) or software command (dynamic). The static address is the sum of the address values of switches set to “OFF” in dual notification. In the example on the left, address is set to “1” (only the switch 1 is active). Address “3” would mean setting dip switch “1” and “2” to “OFF”. If all 6 address switches are set to “ON”, the address is assigned dynamically via software command. CAN-bus If the module is the first or the last in the modul e chain, the SW-term switch (CAN-bus termination sw itch) must be set to ON, otherwise it must be OFF. This is very important for correct working! Enter a code to open a handle Use keypad only: Enter the handle number (left LED = green) and press the button 'E' (left LED = yellow). Type the ACN (access code number) assigned for this lock and press 'E' (left LED flashes yellow). If the code was excepted, left LED flashes green and selected lock will be released, else LED shows red. Use keypad with card reader: Enter handle number (l eft LED = green) and press the button 'E' twice (le ft LED = yellow) and show card to the reader. If card is permitted, selected lock will be released. Use keypad with 2-factor-authentication: Enter the handle number, press 'E', enter personal PIN code, press 'E' and show card to the reader. If both factors match, selected lock will be released.